[U-Boot] [PATCH v3 1/2] watchdog/denali: Adding DesignWare watchdog driver support

* [U-Boot] [PATCH v3 1/2] watchdog/denali: Adding DesignWare watchdog driver support
@ 2014-02-21 20:57 Chin Liang See
  2014-02-24  7:51 ` Michal Simek
  0 siblings, 1 reply; 4+ messages in thread
From: Chin Liang See @ 2014-02-21 20:57 UTC (permalink / raw)
  To: u-boot

To add the DesignWare watchdog driver support. It required
information such as register base address and clock info from
configuration header file  within include/configs folder.

Signed-off-by: Chin Liang See <clsee@altera.com>
Cc: Anatolij Gustschin <agust@denx.de>
Cc: Albert Aribaud <albert.u.boot@aribaud.net>
Cc: Heiko Schocher <hs@denx.de>
Cc: Tom Rini <trini@ti.com>
---
Changes for v3
- Split to 2 series patch
Changes for v2
- Enable this driver at socfpga_cyclone5 board
---
 drivers/watchdog/Makefile         |    1 +
 drivers/watchdog/designware_wdt.c |   73 +++++++++++++++++++++++++++++++++++++
 2 files changed, 74 insertions(+)
 create mode 100644 drivers/watchdog/designware_wdt.c

diff --git a/drivers/watchdog/Makefile b/drivers/watchdog/Makefile
index 06ced10..0276a10 100644
--- a/drivers/watchdog/Makefile
+++ b/drivers/watchdog/Makefile
@@ -15,3 +15,4 @@ obj-$(CONFIG_S5P)               += s5p_wdt.o
 obj-$(CONFIG_XILINX_TB_WATCHDOG) += xilinx_tb_wdt.o
 obj-$(CONFIG_BFIN_WATCHDOG)  += bfin_wdt.o
 obj-$(CONFIG_OMAP_WATCHDOG) += omap_wdt.o
+obj-$(CONFIG_DESIGNWARE_WATCHDOG) += designware_wdt.o
diff --git a/drivers/watchdog/designware_wdt.c b/drivers/watchdog/designware_wdt.c
new file mode 100644
index 0000000..cb88844
--- /dev/null
+++ b/drivers/watchdog/designware_wdt.c
@@ -0,0 +1,73 @@
+/*
+ * Copyright (C) 2013 Altera Corporation <www.altera.com>
+ *
+ * SPDX-License-Identifier:	GPL-2.0+
+ */
+
+#include <common.h>
+#include <watchdog.h>
+#include <asm/io.h>
+#include <asm/utils.h>
+
+#define DW_WDT_CR	0x00
+#define DW_WDT_TORR	0x04
+#define DW_WDT_CRR	0x0C
+
+#define DW_WDT_CR_EN_OFFSET	0x00
+#define DW_WDT_CR_RMOD_OFFSET	0x01
+#define DW_WDT_CR_RMOD_VAL	0x00
+#define DW_WDT_CRR_RESTART_VAL	0x76
+
+/*
+ * Set the watchdog time interval.
+ * Counter is 32 bit.
+ */
+int designware_wdt_settimeout(unsigned int timeout)
+{
+	signed int i;
+	/* calculate the timeout range value */
+	i = (log_2_n_round_up(timeout * CONFIG_DW_WDT_CLOCK_KHZ)) - 16;
+	if (i > 15)
+		i = 15;
+	if (i < 0)
+		i = 0;
+
+	writel((i | (i<<4)), (CONFIG_DW_WDT_BASE + DW_WDT_TORR));
+	return 0;
+}
+
+void designware_wdt_enable(void)
+{
+	writel(((DW_WDT_CR_RMOD_VAL << DW_WDT_CR_RMOD_OFFSET) | \
+	      (0x1 << DW_WDT_CR_EN_OFFSET)),
+	      (CONFIG_DW_WDT_BASE + DW_WDT_CR));
+}
+
+unsigned int designware_wdt_is_enabled(void)
+{
+	unsigned long val;
+	val = readl((CONFIG_DW_WDT_BASE + DW_WDT_CR));
+	return val & 0x1;
+}
+
+#if defined(CONFIG_HW_WATCHDOG)
+void hw_watchdog_reset(void)
+{
+	if (designware_wdt_is_enabled())
+		/* restart the watchdog counter */
+		writel(DW_WDT_CRR_RESTART_VAL,
+		      (CONFIG_DW_WDT_BASE + DW_WDT_CRR));
+}
+
+void hw_watchdog_init(void)
+{
+	/* reset to disable the watchdog */
+	hw_watchdog_reset();
+	/* set timer in miliseconds */
+	designware_wdt_settimeout(CONFIG_HW_WATCHDOG_TIMEOUT_MS);
+	/* enable the watchdog */
+	designware_wdt_enable();
+	/* reset the watchdog */
+	hw_watchdog_reset();
+}
+#endif
-- 
1.7.9.5

^ permalink raw reply related	[flat|nested] 4+ messages in thread