From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stefano Babic Date: Fri, 11 Jul 2014 09:42:02 +0200 Subject: [U-Boot] [PATCH 2/2] mx6: Adjust the GPR offset for mx6solox In-Reply-To: <1404939595-16151-2-git-send-email-festevam@gmail.com> References: <1404939595-16151-1-git-send-email-festevam@gmail.com> <1404939595-16151-2-git-send-email-festevam@gmail.com> Message-ID: <53BF954A.5030800@denx.de> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Fabio, On 09/07/2014 22:59, Fabio Estevam wrote: > From: Fabio Estevam > > On mx6solox there is an additional 0x4000 offset for the GPR registers. > > Signed-off-by: Fabio Estevam > --- > This applies against 'next' branch. > > arch/arm/include/asm/arch-mx6/imx-regs.h | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/arch/arm/include/asm/arch-mx6/imx-regs.h b/arch/arm/include/asm/arch-mx6/imx-regs.h > index 782d9c4..cc746b8 100644 > --- a/arch/arm/include/asm/arch-mx6/imx-regs.h > +++ b/arch/arm/include/asm/arch-mx6/imx-regs.h > @@ -398,6 +398,9 @@ struct src { > > > struct iomuxc { > +#ifdef CONFIG_MX6SX > + u8 reserved[0x4000]; > +#endif > u32 gpr[14]; > u32 omux[5]; > /* mux and pad registers */ > Acked-by: Stefano Babic Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================