Re: [Xen-Devel] Enabling IRQ Crossbar (Secondary Interrupt Controller) Support

From: Brandon Perez <a0225893@ti.com>
To: Ian Campbell <ian.campbell@citrix.com>,
	Julien Grall <julien.grall@citrix.com>,
	xen-devel@lists.xen.org
Cc: Stefano Stabellini <Stefano.Stabellini@eu.citrix.com>
Subject: Re: [Xen-Devel] Enabling IRQ Crossbar (Secondary Interrupt Controller) Support
Date: Thu, 30 Jul 2015 09:45:14 -0400	[thread overview]
Message-ID: <55BA2A6A.6060309@ti.com> (raw)
In-Reply-To: <1438255387.11600.305.camel@citrix.com>

On 07/30/2015 07:23 AM, Ian Campbell wrote:
> On Wed, 2015-07-29 at 16:36 -0400, Brandon Perez wrote:
>> On 07/21/2015 11:12 AM, Ian Campbell wrote:
>>> On Tue, 2015-07-21 at 10:07 -0400, Brandon Perez wrote:
>>>>
>>>>        I'm not sure that these patches are quite ready yet to be put
>>>> into
>>>> the Xen repo.
>>>
>>> That's ok, but even for an RFC (Request For Comments) please post them
>>> one patch per email in the manner of git send-email. You can use -
>>> -subject-prefix='PATCH RFC' to tag them as such.
>>>
>>> Thanks,
>>> Ian.
>>>
>>
>> All,
>>
>>       Apologies for the delay, I've been pretty busy the last week. Also,
>> sorry for the confusion with sending the patches, this is my first time
>> working with an open-source dev group.
>>
>>       I've sent the patches, one per email, via git.
>
> They were "From: bperez-1@ti.com", which bounces my replies. I can resend
> if you are not subscribed to the list or you can fish them out of the
> archives I guess.
>
> Ian.
>

Apologies, I mistyped my email address. It should be "b-perez1@ti.com".

Brandon