On Mar 5, 2014, at 9:53 AM, Wenyou Yang <wenyou.yang@atmel.com> wrote:

> In order to support the pinctrl sleep state.

As I said before NACK

this is not the job of the pinctrl to describe gpio output or input state

Best Regards,
J.
> 
> Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
> ---
> Hi Linus,
> 
> The patch is based on branch: for-next
> git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-pinctrl
> 
> Best Regards,
> Wenyou Yang
> 
> drivers/pinctrl/pinctrl-at91.c     |   31 +++++++++++++++++++++++++++++++
> include/dt-bindings/pinctrl/at91.h |    2 ++
> 2 files changed, 33 insertions(+)
> 
> diff --git a/drivers/pinctrl/pinctrl-at91.c b/drivers/pinctrl/pinctrl-at91.c
> index 5d24aae..fc51e59 100644
> --- a/drivers/pinctrl/pinctrl-at91.c
> +++ b/drivers/pinctrl/pinctrl-at91.c
> @@ -62,6 +62,8 @@ static int gpio_banks;
> #define DEGLITCH	(1 << 2)
> #define PULL_DOWN	(1 << 3)
> #define DIS_SCHMIT	(1 << 4)
> +#define GPIO_OUTPUT_HIGH	(1 << 5)
> +#define GPIO_OUTPUT_LOW		(1 << 6)
> #define DEBOUNCE	(1 << 16)
> #define DEBOUNCE_VAL_SHIFT	17
> #define DEBOUNCE_VAL	(0x3fff << DEBOUNCE_VAL_SHIFT)
> @@ -152,12 +154,15 @@ struct at91_pinctrl_mux_ops {
> 	void (*set_pulldown)(void __iomem *pio, unsigned mask, bool is_on);
> 	bool (*get_schmitt_trig)(void __iomem *pio, unsigned pin);
> 	void (*disable_schmitt_trig)(void __iomem *pio, unsigned mask);
> +	bool (*get_gpio_output)(void __iomem *pio, unsigned mask);
> +	void (*set_gpio_output)(void __iomem *pio, unsigned mask, bool is_high);
> 	/* irq */
> 	int (*irq_type)(struct irq_data *d, unsigned type);
> };
> 
> static int gpio_irq_type(struct irq_data *d, unsigned type);
> static int alt_gpio_irq_type(struct irq_data *d, unsigned type);
> +static void at91_mux_gpio_enable(void __iomem *pio, unsigned mask, bool input);
> 
> struct at91_pinctrl {
> 	struct device		*dev;
> @@ -472,6 +477,20 @@ static bool at91_mux_pio3_get_schmitt_trig(void __iomem *pio, unsigned pin)
> 	return (__raw_readl(pio + PIO_SCHMITT) >> pin) & 0x1;
> }
> 
> +static bool at91_mux_pio3_get_gpio_output(void __iomem *pio, unsigned pin)
> +{
> +	return (__raw_readl(pio + PIO_ODSR) >> pin) & 0x1;
> +}
> +
> +static void at91_mux_pio3_set_gpio_output(void __iomem *pio,
> +						unsigned mask,
> +						bool is_high)
> +{
> +	at91_mux_gpio_enable(pio, mask, 0);
> +	writel_relaxed(mask, pio + (is_high ? PIO_SODR : PIO_CODR));
> +}
> +
> +
> static struct at91_pinctrl_mux_ops at91rm9200_ops = {
> 	.get_periph	= at91_mux_get_periph,
> 	.mux_A_periph	= at91_mux_set_A_periph,
> @@ -495,6 +514,8 @@ static struct at91_pinctrl_mux_ops at91sam9x5_ops = {
> 	.set_pulldown	= at91_mux_pio3_set_pulldown,
> 	.get_schmitt_trig = at91_mux_pio3_get_schmitt_trig,
> 	.disable_schmitt_trig = at91_mux_pio3_disable_schmitt_trig,
> +	.get_gpio_output = at91_mux_pio3_get_gpio_output,
> +	.set_gpio_output = at91_mux_pio3_set_gpio_output,
> 	.irq_type	= alt_gpio_irq_type,
> };
> 
> @@ -741,6 +762,10 @@ static int at91_pinconf_get(struct pinctrl_dev *pctldev,
> 		*config |= PULL_DOWN;
> 	if (info->ops->get_schmitt_trig && info->ops->get_schmitt_trig(pio, pin))
> 		*config |= DIS_SCHMIT;
> +	if (info->ops->get_gpio_output) {
> +		*config |= info->ops->get_gpio_output(pio, pin) ?
> +					GPIO_OUTPUT_HIGH : GPIO_OUTPUT_LOW;
> +	}
> 
> 	return 0;
> }
> @@ -778,6 +803,12 @@ static int at91_pinconf_set(struct pinctrl_dev *pctldev,
> 			info->ops->set_pulldown(pio, mask, config & PULL_DOWN);
> 		if (info->ops->disable_schmitt_trig && config & DIS_SCHMIT)
> 			info->ops->disable_schmitt_trig(pio, mask);
> +		if (info->ops->set_gpio_output) {
> +			if (config & GPIO_OUTPUT_HIGH)
> +				info->ops->set_gpio_output(pio, mask, 1);
> +			if (config & GPIO_OUTPUT_LOW)
> +				info->ops->set_gpio_output(pio, mask, 0);
> +		};
> 
> 	} /* for each config */
> 
> diff --git a/include/dt-bindings/pinctrl/at91.h b/include/dt-bindings/pinctrl/at91.h
> index 0fee6ff..e799268 100644
> --- a/include/dt-bindings/pinctrl/at91.h
> +++ b/include/dt-bindings/pinctrl/at91.h
> @@ -15,6 +15,8 @@
> #define AT91_PINCTRL_DEGLITCH		(1 << 2)
> #define AT91_PINCTRL_PULL_DOWN		(1 << 3)
> #define AT91_PINCTRL_DIS_SCHMIT		(1 << 4)
> +#define AT91_PINCTRL_OUTPUT_HIGH	(1 << 5)
> +#define AT91_PINCTRL_OUTPUT_LOW		(1 << 6)
> #define AT91_PINCTRL_DEBOUNCE		(1 << 16)
> #define AT91_PINCTRL_DEBOUNCE_VAL(x)	(x << 17)
> 
> -- 
> 1.7.9.5
>