All of lore.kernel.org
 help / color / mirror / Atom feed
From: Marijn Suijten <marijn.suijten@somainline.org>
To: Abhinav Kumar <abhinavk@codeaurora.org>, dri-devel@lists.freedesktop.org
Cc: linux-arm-msm@vger.kernel.org, freedreno@lists.freedesktop.org,
	robdclark@gmail.com, seanpaul@chromium.org, swboyd@chromium.org,
	nganji@codeaurora.org, aravindh@codeaurora.org,
	khsieh@codeaurora.org, dmitry.baryshkov@linaro.org
Subject: Re: [PATCH v2 2/2] drm/msm/dsi: add support for dsi test pattern generator
Date: Wed, 11 Aug 2021 01:01:27 +0200	[thread overview]
Message-ID: <6f4f6a68-6da2-2cf7-4772-3947b287be10@somainline.org> (raw)
In-Reply-To: <1626922232-29105-2-git-send-email-abhinavk@codeaurora.org>

Hi Abhinav,

On 7/22/21 4:50 AM, Abhinav Kumar wrote:
> During board bringups its useful to have a DSI test pattern
> generator to isolate a DPU vs a DSI issue and focus on the relevant
> hardware block.
> 
> To facilitate this, add an API which triggers the DSI controller
> test pattern. The expected output is a rectangular checkered pattern.
> 
> This has been validated on a single DSI video mode panel by calling it
> right after drm_panel_enable() which is also the ideal location to use
> this as the DSI host and the panel have been initialized by then.
> 
> Further validation on dual DSI and command mode panel is pending.
> If there are any fix ups needed for those, it shall be applied on top
> of this change.
> 
> Changes in v2:
>   - generate the new dsi.xml.h and update the bitfield names
> 
> Signed-off-by: Abhinav Kumar <abhinavk@codeaurora.org>

Reviewed-by: Marijn Suijten <marijn.suijten@somainline.org>

And tested on Sony phones powered by MSM8956, SDM630, and SM6125.

> ---
>   drivers/gpu/drm/msm/dsi/dsi.h         |  3 ++
>   drivers/gpu/drm/msm/dsi/dsi_host.c    | 61 +++++++++++++++++++++++++++++++++++
>   drivers/gpu/drm/msm/dsi/dsi_manager.c | 13 ++++++++
>   3 files changed, 77 insertions(+)
> 
> diff --git a/drivers/gpu/drm/msm/dsi/dsi.h b/drivers/gpu/drm/msm/dsi/dsi.h
> index 9b8e9b0..663ccbd 100644
> --- a/drivers/gpu/drm/msm/dsi/dsi.h
> +++ b/drivers/gpu/drm/msm/dsi/dsi.h
> @@ -84,6 +84,7 @@ void msm_dsi_manager_setup_encoder(int id);
>   int msm_dsi_manager_register(struct msm_dsi *msm_dsi);
>   void msm_dsi_manager_unregister(struct msm_dsi *msm_dsi);
>   bool msm_dsi_manager_validate_current_config(u8 id);
> +void msm_dsi_manager_tpg_enable(void);
>   
>   /* msm dsi */
>   static inline bool msm_dsi_device_connected(struct msm_dsi *msm_dsi)
> @@ -148,6 +149,8 @@ int dsi_clk_init_6g_v2(struct msm_dsi_host *msm_host);
>   int dsi_calc_clk_rate_v2(struct msm_dsi_host *msm_host, bool is_dual_dsi);
>   int dsi_calc_clk_rate_6g(struct msm_dsi_host *msm_host, bool is_dual_dsi);
>   void msm_dsi_host_snapshot(struct msm_disp_state *disp_state, struct mipi_dsi_host *host);
> +void msm_dsi_host_test_pattern_en(struct mipi_dsi_host *host);
> +
>   /* dsi phy */
>   struct msm_dsi_phy;
>   struct msm_dsi_phy_shared_timings {
> diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c
> index ed504fe..e0a3581 100644
> --- a/drivers/gpu/drm/msm/dsi/dsi_host.c
> +++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
> @@ -2495,3 +2495,64 @@ void msm_dsi_host_snapshot(struct msm_disp_state *disp_state, struct mipi_dsi_ho
>   
>   	pm_runtime_put_sync(&msm_host->pdev->dev);
>   }
> +
> +static void msm_dsi_host_video_test_pattern_setup(struct msm_dsi_host *msm_host)
> +{
> +	u32 reg;
> +
> +	reg = dsi_read(msm_host, REG_DSI_TEST_PATTERN_GEN_CTRL);
> +
> +	dsi_write(msm_host, REG_DSI_TEST_PATTERN_GEN_VIDEO_INIT_VAL, 0xff);
> +	/* draw checkered rectangle pattern */
> +	dsi_write(msm_host, REG_DSI_TPG_MAIN_CONTROL,
> +			DSI_TPG_MAIN_CONTROL_CHECKERED_RECTANGLE_PATTERN);
> +	/* use 24-bit RGB test pttern */


pattern*

> +	dsi_write(msm_host, REG_DSI_TPG_VIDEO_CONFIG,
> +			DSI_TPG_VIDEO_CONFIG_BPP(VIDEO_CONFIG_24BPP) |
> +			DSI_TPG_VIDEO_CONFIG_RGB);
> +
> +	reg |= DSI_TEST_PATTERN_GEN_CTRL_VIDEO_PATTERN_SEL(VID_MDSS_GENERAL_PATTERN);
> +	dsi_write(msm_host, REG_DSI_TEST_PATTERN_GEN_CTRL, reg);
> +
> +	DBG("Video test pattern setup done\n");
> +}
> +
> +static void msm_dsi_host_cmd_test_pattern_setup(struct msm_dsi_host *msm_host)
> +{
> +	u32 reg;
> +
> +	reg = dsi_read(msm_host, REG_DSI_TEST_PATTERN_GEN_CTRL);
> +
> +	/* initial value for test pattern */
> +	dsi_write(msm_host, REG_DSI_TEST_PATTERN_GEN_CMD_MDP_INIT_VAL0, 0xff);
> +
> +	reg |= DSI_TEST_PATTERN_GEN_CTRL_CMD_MDP_STREAM0_PATTERN_SEL(CMD_MDP_MDSS_GENERAL_PATTERN);
> +
> +	dsi_write(msm_host, REG_DSI_TEST_PATTERN_GEN_CTRL, reg);
> +	/* draw checkered rectangle pattern */
> +	dsi_write(msm_host, REG_DSI_TPG_MAIN_CONTROL2,
> +			DSI_TPG_MAIN_CONTROL2_CMD_MDP0_CHECKERED_RECTANGLE_PATTERN);
> +
> +	DBG("Cmd test pattern setup done\n");
> +}
> +
> +void msm_dsi_host_test_pattern_en(struct mipi_dsi_host *host)
> +{
> +	struct msm_dsi_host *msm_host = to_msm_dsi_host(host);
> +	bool is_video_mode = !!(msm_host->mode_flags & MIPI_DSI_MODE_VIDEO);
> +	u32 reg;
> +
> +	if (is_video_mode)
> +		msm_dsi_host_video_test_pattern_setup(msm_host);
> +	else
> +		msm_dsi_host_cmd_test_pattern_setup(msm_host);
> +
> +	reg = dsi_read(msm_host, REG_DSI_TEST_PATTERN_GEN_CTRL);
> +	/* enable the test pattern generator */
> +	dsi_write(msm_host, REG_DSI_TEST_PATTERN_GEN_CTRL, (reg | DSI_TEST_PATTERN_GEN_CTRL_EN));
> +
> +	/* for command mode need to trigger one frame from tpg */
> +	if (!is_video_mode)
> +		dsi_write(msm_host, REG_DSI_TEST_PATTERN_GEN_CMD_STREAM0_TRIGGER,
> +				DSI_TEST_PATTERN_GEN_CMD_STREAM0_TRIGGER_SW_TRIGGER);
> +}
> diff --git a/drivers/gpu/drm/msm/dsi/dsi_manager.c b/drivers/gpu/drm/msm/dsi/dsi_manager.c
> index 4ebfedc..db80de6 100644
> --- a/drivers/gpu/drm/msm/dsi/dsi_manager.c
> +++ b/drivers/gpu/drm/msm/dsi/dsi_manager.c
> @@ -441,6 +441,19 @@ static void dsi_mgr_bridge_pre_enable(struct drm_bridge *bridge)
>   	return;
>   }
>   
> +void msm_dsi_manager_tpg_enable(void)
> +{
> +	struct msm_dsi *m_dsi = dsi_mgr_get_dsi(DSI_0);
> +	struct msm_dsi *s_dsi = dsi_mgr_get_dsi(DSI_1);
> +
> +	/* if dual dsi, trigger tpg on master first then slave */
> +	if (m_dsi) {
> +		msm_dsi_host_test_pattern_en(m_dsi->host);
> +		if (IS_DUAL_DSI() && s_dsi)
> +			msm_dsi_host_test_pattern_en(s_dsi->host);
> +	}
> +}
> +
>   static void dsi_mgr_bridge_enable(struct drm_bridge *bridge)
>   {
>   	int id = dsi_mgr_bridge_get_id(bridge);
> 

Marijn

  parent reply	other threads:[~2021-08-10 23:01 UTC|newest]

Thread overview: 9+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-07-22  2:50 [PATCH v2 1/2] drm/msm/dsi: update dsi register header file for tpg Abhinav Kumar
2021-07-22  2:50 ` Abhinav Kumar
2021-07-22  2:50 ` [PATCH v2 2/2] drm/msm/dsi: add support for dsi test pattern generator Abhinav Kumar
2021-07-22  2:50   ` Abhinav Kumar
2021-07-22 20:20   ` Stephen Boyd
2021-07-22 20:20     ` Stephen Boyd
2021-08-10 23:01   ` Marijn Suijten [this message]
2021-07-22 20:19 ` [PATCH v2 1/2] drm/msm/dsi: update dsi register header file for tpg Stephen Boyd
2021-07-22 20:19   ` Stephen Boyd

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=6f4f6a68-6da2-2cf7-4772-3947b287be10@somainline.org \
    --to=marijn.suijten@somainline.org \
    --cc=abhinavk@codeaurora.org \
    --cc=aravindh@codeaurora.org \
    --cc=dmitry.baryshkov@linaro.org \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=freedreno@lists.freedesktop.org \
    --cc=khsieh@codeaurora.org \
    --cc=linux-arm-msm@vger.kernel.org \
    --cc=nganji@codeaurora.org \
    --cc=robdclark@gmail.com \
    --cc=seanpaul@chromium.org \
    --cc=swboyd@chromium.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.