Re: [PATCH v3 03/16] dt-bindings: qcom_nandc: make nand-ecc-strength optional

[Abhishek Sahu <absahu@codeaurora.org>]

On 2018-05-26 14:12, Miquel Raynal wrote:
> Hi Abhishek,
> 
> On Fri, 25 May 2018 17:51:31 +0530, Abhishek Sahu
> <absahu@codeaurora.org> wrote:
> 
>> If nand-ecc-strength specified in DT, then controller will use
>> this ECC strength otherwise ECC strength will be calculated
>> according to chip requirement and available OOB size.
>> 
>> Signed-off-by: Abhishek Sahu <absahu@codeaurora.org>
>> ---
>> * Changes from v2:
>>   NONE
>> 
>> * Changes from v1:
>>   NEW PATCH
>> 
>>  Documentation/devicetree/bindings/mtd/qcom_nandc.txt | 4 +++-
>>  1 file changed, 3 insertions(+), 1 deletion(-)
>> 
>> diff --git a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt 
>> b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt
>> index 73d336be..f246aa0 100644
>> --- a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt
>> +++ b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt
>> @@ -45,11 +45,13 @@ Required properties:
>>  			number (e.g., 0, 1, 2, etc.)
>>  - #address-cells:	see partition.txt
>>  - #size-cells:		see partition.txt
>> -- nand-ecc-strength:	see nand.txt
>>  - nand-ecc-step-size:	must be 512. see nand.txt for more details.
> 
> I think you can squash the two dt-bindings commits as they are tightly
> related to each other.
> 

  Sure Miquel.
  Earlier made one patch and then split into two.
  Will squash that and make single patch again :-)

  Thanks,
  Abhishek

>> 
>>  Optional properties:
>>  - nand-bus-width:	see nand.txt
>> +- nand-ecc-strength:	see nand.txt. If not specified, then ECC 
>> strength will
>> +			be used according to chip requirement and available
>> +			OOB size.
>> 
>>  Each nandcs device node may optionally contain a 'partitions' 
>> sub-node, which
>>  further contains sub-nodes describing the flash partition mapping. 
>> See