[U-Boot] [PATCH 2/2] spl: socfpga: stratix10: add hex file output for spl image

[Marek Vasut <marex@denx.de>]

On 08/20/2018 11:04 PM, Dalon L Westergreen wrote:
> On Mon, 2018-08-20 at 20:33 +0200, Marek Vasut wrote:
>> On 08/20/2018 03:54 PM, Dalon Westergreen wrote:
>> Stratix10 requires a hex image of the spl for boot.  The hex
>> image is added to the FPGA configuration image and loaded to
>> the processor memory by the configuration engine.
>>
>> Signed-off-by: Dalon Westergreen <dwesterg at gmail.com <mailto:dwesterg@gmail.com>>
>> ---
>>  scripts/Makefile.spl | 10 ++++++++++
>>  1 file changed, 10 insertions(+)
>>
>> diff --git a/scripts/Makefile.spl b/scripts/Makefile.spl
>> index 76d08fd92b..c424f87e6e 100644
>> --- a/scripts/Makefile.spl
>> +++ b/scripts/Makefile.spl
>> @@ -190,6 +190,7 @@ endif
>>  ifdef CONFIG_ARCH_SOCFPGA
>>  ALL-$(CONFIG_TARGET_SOCFPGA_GEN5)	+= $(obj)/$(SPL_BIN).sfp
>>  ALL-$(CONFIG_TARGET_SOCFPGA_ARRIA10)	+= $(obj)/$(SPL_BIN).sfp
>> +ALL-$(CONFIG_TARGET_SOCFPGA_STRATIX10)	+= $(obj)/$(SPL_BIN).hex
>>  endif
>>  
>>  ifdef CONFIG_ARCH_SUNXI
>> @@ -299,6 +300,15 @@ OBJCOPYFLAGS_u-boot-x86-16bit-spl.bin := -O binary -j .start16 -j .resetvec
>>  $(obj)/u-boot-x86-16bit-spl.bin: $(obj)/u-boot-spl FORCE
>>  	$(call if_changed,objcopy)
>>  
>> +ifdef CONFIG_TARGET_SOCFPGA_STRATIX10
>> +OBJCOPYFLAGS_$(SPL_BIN).hex = -I binary -O ihex --change-addresses 0xffe00000
>>
>> Why is this --change-address needed ? This smells like a hack of some
>> sort ...
>>
> I believe the tool that uses this file expects this offset, that said i have not
> 
> tried using a hex file without this change address applied.  I will try without 
> 
> this, and see what happens.

You probably need to adjust the link address of the SPL or U-Boot too.

-- 
Best regards,
Marek Vasut