Re: How is IPv6 dhcp supposed to work?

From: "Bjørn Mork" <bjorn@mork.no>
To: Ben Greear <greearb@candelatech.com>
Cc: Dan Williams <dcbw@redhat.com>, netdev <netdev@vger.kernel.org>
Subject: Re: How is IPv6 dhcp supposed to work?
Date: Wed, 18 Jun 2014 12:37:37 +0200	[thread overview]
Message-ID: <87ha3isdu6.fsf@nemi.mork.no> (raw)
In-Reply-To: <53A0CC31.6090707@candelatech.com> (Ben Greear's message of "Tue, 17 Jun 2014 16:16:01 -0700")

Ben Greear <greearb@candelatech.com> writes:

> Does that router advert below look proper? 

No, it doesn't.  How did you create this?

> I'm going printk diving in
> the IPv6 stack in the meantime...
>
>
> [root@simech2-f17x64 lanforge]# cat pkt.txt
> No.     Time        Source                Destination           Protocol Length Info
>      34 229.636063  fe80::e4be:86ff:fe27:a33 ff02::1               ICMPv6   110    Router Advertisement from e6:be:86:27:0a:33
>
> Frame 34: 110 bytes on wire (880 bits), 110 bytes captured (880 bits)
> Ethernet II, Src: e6:be:86:27:0a:33 (e6:be:86:27:0a:33), Dst: IPv6mcast_00:00:00:01 (33:33:00:00:00:01)
> Internet Protocol Version 6, Src: fe80::e4be:86ff:fe27:a33 (fe80::e4be:86ff:fe27:a33), Dst: ff02::1 (ff02::1)
> Internet Control Message Protocol v6
>     Type: Router Advertisement (134)
>     Code: 0
>     Checksum: 0x6088 [correct]
>     Cur hop limit: 64
>     Flags: 0x00
>     Router lifetime (s): 300
>     Reachable time (ms): 0
>     Retrans timer (ms): 0
>     ICMPv6 Option (Prefix information : 2001:78::1/64)
>         Type: Prefix information (3)
>         Length: 4 (32 bytes)
>         Prefix Length: 64
>         Flag: 0xe0
>         Valid Lifetime: 86400
>         Preferred Lifetime: 14400
>         Reserved
>         Prefix: 2001:78::1 (2001:78::1)

Quoting RFC 4861 (http://tools.ietf.org/html/rfc4861#section-4.6.2 ):

      Prefix         An IP address or a prefix of an IP address.  The
                     Prefix Length field contains the number of valid
                     leading bits in the prefix.  The bits in the prefix
                     after the prefix length are reserved and MUST be
                     initialized to zero by the sender and ignored by
                     the receiver. 

So that prefix should have been '2001:78::'

Note that you don't necessarily need to include a prefix option in the
RA.  If you don't want clients on the link connected to the router to
communicate directly on L2.  This is the typical ISP use case.

Bjørn