From mboxrd@z Thu Jan 1 00:00:00 1970 From: icenowy@aosc.io (Icenowy Zheng) Date: Tue, 06 Feb 2018 10:51:04 +0800 Subject: [linux-sunxi] [PATCH v3] ARM: sun8i: h2+: add support for Banana Pi M2 Zero board In-Reply-To: <20180205133625.vcz73qck5kfihalv@flea> References: <20171224054029.12278-1-icenowy@aosc.io> <20180205133625.vcz73qck5kfihalv@flea> Message-ID: To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org ? 2018?2?5? GMT+08:00 ??9:36:25, Maxime Ripard ??: >On Sat, Feb 03, 2018 at 05:45:52PM +1100, Julian Calaby wrote: >> Hi all, >> >> On Sun, Dec 24, 2017 at 4:40 PM, Icenowy Zheng >wrote: >> > Banana Pi M2 Zero board is a H2+-based board by Sinovoip, with a >form >> > factor and GPIO holes similar to Raspberry Pi Zero. >> > >> > It features: >> > - Allwinner H2+ SoC >> > - Single-chip (16-bit) 512MiB DDR3 DRAM >> > - Ampak AP6212 Wi-Fi/Bluetooth module >> > - MicroSD slot >> > - Two MicroUSB Type-B ports (one can only be used to power the >board and >> > the other features OTG functionality) >> > - Two keys, a reset and a GPIO-connected key. >> > - HDMI Type-C (miniHDMI) connector connected to the HDMI part of >H2+. >> > - CSI connector to connect the camera sensor provided by Sinovoip. >> > >> > Signed-off-by: Icenowy Zheng >> >> [Trimmed lots of non-sunxi-specific mailing lists] >> >> Did support for this board ever get merged? > >It doesn't look like it did. Is there any problem in this patch now except the absense of SPDX license usage? > >> (I have two of them now, so if it didn't, I'll try to shepherd this >> and it's corresponding u-boot patch upstream.) > >That sounds great :) > >Maxime