From mboxrd@z Thu Jan 1 00:00:00 1970 From: York Sun Date: Tue, 20 Nov 2018 16:54:19 +0000 Subject: [U-Boot] [PATCH v3] fsl-lsch3: soc: Enable AHB read support for Flexspi controller References: <20181113072550.23620-1-Ashish.Kumar@nxp.com> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 11/20/18 1:24 AM, Ashish Kumar wrote: > > >> -----Original Message----- >> From: York Sun >> Sent: Tuesday, November 20, 2018 2:13 AM >> To: Ashish Kumar ; u-boot at lists.denx.de >> Cc: Yogesh Narayan Gaur ; Rajat Srivastava >> >> Subject: Re: [PATCH v3] fsl-lsch3: soc: Enable AHB read support for Flexspi >> controller >> >> On 11/12/18 11:26 PM, Ashish Kumar wrote: >>> Enable AHB support for Flexspi controller interface meaning memory can >>> be accessed via md command using absolute addresses >>> >>> Signed-off-by: Yogesh Gaur >>> Signed-off-by: Rajat Srivastava >>> Signed-off-by: Ashish Kumar >>> --- >>> v3: >>> Depends upon http://patchwork.ozlabs.org/patch/975009/ > Hi York, > > Sorry that was typo, it was meant to be http://patchwork.ozlabs.org/patch/974301/. > But unfortunately after lot of delay in review on NXP-FlexSPI driver, it has been asked to re-write to a new frame-work. I think I should defer this http://patchwork.ozlabs.org/patch/975008/ and http://patchwork.ozlabs.org/patch/996846/ for the time being until 974301 is re-written. What do you suggest? > You still need FlexSPI driver, don't you? Please work with Jagan on the driver. York