From mboxrd@z Thu Jan 1 00:00:00 1970 From: Peng Fan Date: Wed, 11 Dec 2019 03:05:49 +0000 Subject: i.MX8MM-EVK Boot failure In-Reply-To: References: Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > Subject: Re: i.MX8MM-EVK Boot failure > > Hi Peng, > > On Tue, Dec 10, 2019 at 10:48 PM Peng Fan wrote: > > > What you modified? It boots well with Tom's tree. > > Does imx8mq-evk also boot for you? > > I followed the imx8mq-evk README instructions and it does not boot here. > > Maybe you are using different ATF/DDR firmware versions? > > Does it work if you follow the README steps? I not download that, just use my local ATF/DDR, U-Boot SPL 2020.01-rc4-00208-g520f955902 (Dec 11 2019 - 11:22:53 +0800) PMIC: PFUZE100 ID=0x10 DDRINFO: start DRAM init DDRINFO:ddrphy calibration done DDRINFO: ddrmix config done Normal Boot Trying to boot from MMC2 NOTICE: Configuring TZASC380 NOTICE: RDC off NOTICE: BL31: v2.0(release):rel_imx_4.14.98_2.3.0_rc1-1-g8138ffe5c-dirty NOTICE: BL31: Built : 03:17:34, Dec 11 2019 NOTICE: sip svc init U-Boot 2020.01-rc4-00208-g520f955902 (Dec 11 2019 - 11:22:53 +0800) CPU: Freescale i.MX8MQ rev2.1 at 1000 MHz Reset cause: POR Model: NXP i.MX8MQ EVK DRAM: 3 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 Loading Environment from MMC... unable to select a mode *** Warning - No block device, using default environment In: serial Out: serial Err: serial Net: Warning: ethernet at 30be0000 using MAC address from ROM eth0: ethernet at 30be0000 Hit any key to stop autoboot: 0 But there is true a mmc env issue here, I am checking. Thanks, Peng. > > Thanks