From mboxrd@z Thu Jan 1 00:00:00 1970 From: Peng Fan Date: Tue, 4 Jun 2019 02:49:32 +0000 Subject: [U-Boot] [PATCH 5/5] mx6sabreauto: set SYS_MALLOC_F for video In-Reply-To: <20190603190029.10373-6-sjoerd.simons@collabora.co.uk> References: <20190603190029.10373-1-sjoerd.simons@collabora.co.uk> <20190603190029.10373-6-sjoerd.simons@collabora.co.uk> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de > Subject: [PATCH 5/5] mx6sabreauto: set SYS_MALLOC_F for video > > Sabre Auto boards currently hang with: > ``` > U-Boot 2019.07-rc3-00057-gc41940c406 (Jun 03 2019 - 14:42:41 +0200) > > CPU: Freescale i.MX6QP rev1.0 996 MHz (running at 792 MHz) > CPU: Automotive temperature grade (-40C to 125C)Reset cause: WDOG > Model: Freescale i.MX6 Quad Plus SABRE Automotive Board > Board: MX6Q-Sabreauto revA > I2C: ready > DRAM: 2 GiB > Video device 'ipu at 2400000' cannot allocate frame buffer memory -ensure > the device is set up before relocation Error binding driver 'ipuv3_video': -28 > Video device 'ipu at 2800000' cannot allocate frame buffer memory -ensure > the device is set up before relocation Error binding driver 'ipuv3_video': -28 > Some drivers failed to bind Error binding driver 'generic_simple_bus': -28 > Some drivers failed to bind initcall sequence 8ffe00b8 failed at call 1780e93b > (err=-28) ``` > > Set SYS_MALLOC_F_LEN to reserve_video to work. > > This is similar to the change Peng Fan did for mx6sabresd (9002e735e717) > > Signed-off-by: Sjoerd Simons > > --- > > configs/mx6sabreauto_defconfig | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/configs/mx6sabreauto_defconfig > b/configs/mx6sabreauto_defconfig index 6903048d85..558b1cd996 100644 > --- a/configs/mx6sabreauto_defconfig > +++ b/configs/mx6sabreauto_defconfig > @@ -4,6 +4,7 @@ CONFIG_SYS_TEXT_BASE=0x17800000 > CONFIG_SPL_GPIO_SUPPORT=y CONFIG_SPL_LIBCOMMON_SUPPORT=y > CONFIG_SPL_LIBGENERIC_SUPPORT=y > +CONFIG_SYS_MALLOC_F_LEN=0x4000 > CONFIG_TARGET_MX6SABREAUTO=y > CONFIG_SPL_MMC_SUPPORT=y > CONFIG_SPL_SERIAL_SUPPORT=y > @@ -11,7 +12,6 @@ CONFIG_NR_DRAM_BANKS=1 CONFIG_SPL=y > CONFIG_SPL_LIBDISK_SUPPORT=y CONFIG_NXP_BOARD_REVISION=y -# > CONFIG_SYS_MALLOC_F is not set CONFIG_FIT=y > CONFIG_SPL_FIT_PRINT=y CONFIG_SPL_LOAD_FIT=y > -- Reviewed-by: Peng Fan > 2.20.1