From mboxrd@z Thu Jan 1 00:00:00 1970 From: Ale Lampro Subject: Configuring and using RIPngd Date: Wed, 14 Aug 2013 12:02:35 +0200 Message-ID: Mime-Version: 1.0 Content-Type: text/plain; charset=ISO-8859-1 To: netdev@vger.kernel.org Return-path: Received: from mail-vc0-f195.google.com ([209.85.220.195]:33858 "EHLO mail-vc0-f195.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1752411Ab3HNKCg (ORCPT ); Wed, 14 Aug 2013 06:02:36 -0400 Received: by mail-vc0-f195.google.com with SMTP id gd11so1609231vcb.2 for ; Wed, 14 Aug 2013 03:02:35 -0700 (PDT) Sender: netdev-owner@vger.kernel.org List-ID: Hi, I am new to the list and I am trying to achieve something that I think should be relatively easy with RIPngd and Quagga, but I am new to all this so I have some issues. I have two computers connected by a Serial link. I use "tunslip" which creates a slip connection between them and mounts a tap0 interface in my ubuntu linux computer. The other computer generates a Response RIPng message advertising ADDR1 (ipv6 address) in a given moment, which arrives to the linux computer by the tap0 interface. What I would like to do is to run ripng in this computer so that it adds ADDR1 to its routing table but I am not able to do it. The configuration for zebra and ripngd are the following. ripngd: http://pastebin.com/Y8GHkcDB (link to the conf file) zebra: http://pastebin.com/ZEVRfLx0 (link to the conf file) As I was not sure at all of how I should configure them I just reused a few things that I found on the internet but I guess it may not be enough. I would really appreciate if someone could give me a hint with this. Thanks a lot. Best regards, Alejandro