Dear concerned,

 

I have recently started working with I.mx8xqxp. We are developing a MIPI CSI2 to USB3.0 solution using i.MX8QXP customized for automotive radar use. Our radar products transmit raw ADC data over MIPI CSI2 interface and we are using the i.MX8QXP to receive the radar data to send this to PC over USB3.0. We plan to use this solution for data acquisition/radar validation in PL ADAS labs

 

I am new to both Linux and Yocto project and need help. I have managed to deploy the image on the hardware and boot it but I am unable to proceed further and totally confused.

 

I have tried using   source /opt/poky/…but my opt dir is empty so I thought installing tool chain image  bitbake meta-toolchain would solve but my terminal cannot find bitbake command

 

I would like to configure my i.mx board as a mass storage device to test its actual usb 3.0 speed for which there are drivers already available but I don’t know how to proceed with them. Can you please tell me or provide a short guide on how to use/add these drivers.

 

Best Regards,

Abhey Singh Kanwar

Intern

 

NXP Semiconductors Germany GmbH

PL ADAS, BL Car Infotainment & Driver Assistance

Schatzbogen 7

81829 Munich, Germany 

Office: +49(0)89-92103811

Email: abhey.singhkanwar@nxp.com

 

 

Geschäftsführung: Ruediger Stroh (Vors.), Frans Scheper, Kurt Sievers, Erik Just-Wartiainen, Achim Kempe / Aufsichtsratsvorsitzender: Gernot Fiedler / Sitz: Hamburg /

Registergericht: Hamburg HRB 84 865

 

--
_______________________________________________
meta-freescale mailing list
meta-freescale@yoctoproject.org
https://lists.yoctoproject.org/listinfo/meta-freescale