Sorry, one of the email address is wrong. I will correct it and resend. Regards, Leon Luo 1130 Cadillac CT Milpitas, CA 95035 Phone: (510)371-1169 Fax: (408) 217-1960 Email: leonl@leopardimaging.com www.leopardimaging.com On Wed, Aug 30, 2017 at 10:50 AM, Leon Luo wrote: > The binding file for imx274 CMOS sensor V4l2 driver > > Signed-off-by: Leon Luo > Acked-by: Sören Brinkmann > --- > v3: > - remove redundant properties and references > - document 'reg' property > v2: > - no changes > --- > .../devicetree/bindings/media/i2c/imx274.txt | 32 > ++++++++++++++++++++++ > 1 file changed, 32 insertions(+) > create mode 100644 Documentation/devicetree/bindings/media/i2c/imx274.txt > > diff --git a/Documentation/devicetree/bindings/media/i2c/imx274.txt > b/Documentation/devicetree/bindings/media/i2c/imx274.txt > new file mode 100644 > index 000000000000..1f03256b35db > --- /dev/null > +++ b/Documentation/devicetree/bindings/media/i2c/imx274.txt > @@ -0,0 +1,32 @@ > +* Sony 1/2.5-Inch 8.51Mp CMOS Digital Image Sensor > + > +The Sony imx274 is a 1/2.5-inch CMOS active pixel digital image sensor > with > +an active array size of 3864H x 2202V. It is programmable through I2C > +interface. The I2C address is fixed to 0x1a as per sensor data sheet. > +Image data is sent through MIPI CSI-2, which is configured as 4 lanes > +at 1440 Mbps. > + > + > +Required Properties: > +- compatible: value should be "sony,imx274" for imx274 sensor > +- reg: I2C bus address of the device > + > +Optional Properties: > +- reset-gpios: Sensor reset GPIO > + > +For further reading on port node refer to > +Documentation/devicetree/bindings/media/video-interfaces.txt. > + > +Example: > + sensor@1a { > + compatible = "sony,imx274"; > + reg = <0x1a>; > + #address-cells = <1>; > + #size-cells = <0>; > + reset-gpios = <&gpio_sensor 0 0>; > + port { > + sensor_out: endpoint { > + remote-endpoint = <&csiss_in>; > + }; > + }; > + }; > -- > 2.14.0.rc1 > >