Re: [PATCH] hw/arm/xlnx: Fix PHY address for xilinx-zynq-a9

[Peter Maydell <peter.maydell@linaro.org>]

On Tue, 4 May 2021 at 13:41, Guenter Roeck <linux@roeck-us.net> wrote:
>
> Commit dfc388797cc4 ("hw/arm: xlnx: Set all boards' GEM 'phy-addr'
> property value to 23") configured the PHY address for xilinx-zynq-a9
> to 23. When trying to boot xilinx-zynq-a9 with zynq-zc702.dtb or
> zynq-zc706.dtb, this results in the following error message when
> trying to use the Ethernet interface.
>
> macb e000b000.ethernet eth0: Could not attach PHY (-19)
>
> The devicetree files for ZC702 and ZC706 configure PHY address 7. The
> documentation for the ZC702 and ZC706 evaluation boards suggest that the
> PHY address is 7, not 23. Other boards use PHY address 0, 1, 3, or 7.
> I was unable to find a documentation or a devicetree file suggesting
> or using PHY address 23. The Ethernet interface starts working with
> zynq-zc702.dtb and zynq-zc706.dtb when setting the PHY address to 7,
> so let's use it.
>
> Cc: Bin Meng <bin.meng@windriver.com>
> Signed-off-by: Guenter Roeck <linux@roeck-us.net>
> ---
>  hw/arm/xilinx_zynq.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/hw/arm/xilinx_zynq.c b/hw/arm/xilinx_zynq.c
> index 8db6cfd47f..5ac0294f9e 100644
> --- a/hw/arm/xilinx_zynq.c
> +++ b/hw/arm/xilinx_zynq.c
> @@ -119,7 +119,7 @@ static void gem_init(NICInfo *nd, uint32_t base, qemu_irq irq)
>          qemu_check_nic_model(nd, TYPE_CADENCE_GEM);
>          qdev_set_nic_properties(dev, nd);
>      }
> -    object_property_set_int(OBJECT(dev), "phy-addr", 23, &error_abort);
> +    object_property_set_int(OBJECT(dev), "phy-addr", 7, &error_abort);
>      s = SYS_BUS_DEVICE(dev);
>      sysbus_realize_and_unref(s, &error_fatal);
>      sysbus_mmio_map(s, 0, base);
> --
> 2.25.1



Applied to target-arm.next, thanks.

-- PMM