Thank you Paul, I am new to yocto. I am trying to build the image from scratch again and now the package folder is generated. Thanks for the response. On Wed, Jun 4, 2014 at 4:12 PM, Paul Eggleton wrote: > On Wednesday 04 June 2014 20:59:22 Nicolas Dechesne wrote: > > On Wed, Jun 4, 2014 at 8:35 PM, Bharath Chandra > > > > wrote: > > > I want to capture build history while building an image and I have done > > > the > > > following settings in conf/local.conf file. > > > > > > INHERIT += "buildhistory" > > > BUILDHISTORY_COMMIT = "1" > > > > > > as suggested in > > > > http://www.yoctoproject.org/docs/current/ref-manual/ref-manual.html#mainta > > > ining-build-output-quality > > > > > > > > > But, the problem is buildhistory/images folder is being created but > > > buildhistory/packages > > > > > > folder is not being created. Any kind of suggestions on this issue > would > > > be helpful. > > > > maybe a dumb question... but have you actually built any package? if a > > package is re-used from sstate, then it's not built, and no statistics > > are generated. > > This is true of 1.5 and older, but in 1.6, packages whose contents are > restored from shared state *will* be captured in buildhistory. (However, if > you built an image and then afterwards enabled buildhistory and built the > image again, you wouldn't have any package information collected.) > > Cheers, > Paul > > -- > > Paul Eggleton > Intel Open Source Technology Centre > -- Thanks & Regards, Bharath Chandra Elluru. Contact Number:785-979-4875.