All of lore.kernel.org
 help / color / mirror / Atom feed
From: Andy Shevchenko <andy.shevchenko@gmail.com>
To: Paolo Bonzini <pbonzini@redhat.com>
Cc: "linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
	Wim Van Sebroeck <wim@iguana.be>,
	Guenter Roeck <linux@roeck-us.net>,
	linux-watchdog@vger.kernel.org
Subject: Re: [PATCH] iTCO_wdt: all versions count down twice
Date: Wed, 5 Apr 2017 13:31:13 +0300	[thread overview]
Message-ID: <CAHp75VcjjhWzyRu_-qMBE0wW4q38iqxF3jHULi-gOrS4cG+V_w@mail.gmail.com> (raw)
In-Reply-To: <20170405090308.10093-1-pbonzini@redhat.com>

On Wed, Apr 5, 2017 at 12:03 PM, Paolo Bonzini <pbonzini@redhat.com> wrote:
> The ICH9 is listed as having TCO v2, and indeed the behavior in the
> datasheet corresponds to v2 (for example the NO_REBOOT flag is
> accessible via the 16KiB-aligned Root Complex Base Address).
>
> However, the TCO counts twice just like in v1; the documentation
> of the SECOND_TO_STS bit says: "ICH9 sets this bit to 1 to indicate
> that the TIMEOUT bit had been (or is currently) set and a second
> timeout occurred before the TCO_RLD register was written. If this
> bit is set and the NO_REBOOT config bit is 0, then the ICH9 will
> reboot the system after the second timeout.  The same can be found
> in the BayTrail (Atom E3800) datasheet, and even HOWTOs around
> the Internet say that it will reboot after _twice_ the specified
> heartbeat.
>
> I did not find the Apollo Lake datasheet, but because v4/v5 has
> a SECOND_TO_STS bit just like the previous version I'm enabling
> this for Apollo Lake as well.

Regarding to last proposed changes Apollo Lake has some register offset issue.
Nevertheless, this patch AFAIU still applies.

One nit below.
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>

>
> Cc: Wim Van Sebroeck <wim@iguana.be>
> Cc: Guenter Roeck <linux@roeck-us.net>
> Cc: linux-watchdog@vger.kernel.org
> Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
> ---
>  Documentation/watchdog/watchdog-parameters.txt |  2 +-
>  drivers/watchdog/iTCO_wdt.c                    | 23 ++++++++++-------------
>  2 files changed, 11 insertions(+), 14 deletions(-)
>
> diff --git a/Documentation/watchdog/watchdog-parameters.txt b/Documentation/watchdog/watchdog-parameters.txt
> index 4f7d86dd0a5d..914518aeb972 100644
> --- a/Documentation/watchdog/watchdog-parameters.txt
> +++ b/Documentation/watchdog/watchdog-parameters.txt
> @@ -117,7 +117,7 @@ nowayout: Watchdog cannot be stopped once started
>  -------------------------------------------------
>  iTCO_wdt:
>  heartbeat: Watchdog heartbeat in seconds.
> -       (2<heartbeat<39 (TCO v1) or 613 (TCO v2), default=30)
> +       (5<=heartbeat<=74 (TCO v1) or 1226 (TCO v2), default=30)
>  nowayout: Watchdog cannot be stopped once started
>         (default=kernel config parameter)
>  -------------------------------------------------
> diff --git a/drivers/watchdog/iTCO_wdt.c b/drivers/watchdog/iTCO_wdt.c
> index 3d0abc0d59b4..c9230a0cdc83 100644
> --- a/drivers/watchdog/iTCO_wdt.c
> +++ b/drivers/watchdog/iTCO_wdt.c
> @@ -280,16 +280,15 @@ static int iTCO_wdt_ping(struct watchdog_device *wd_dev)
>
>         iTCO_vendor_pre_keepalive(p->smi_res, wd_dev->timeout);
>
> +       /* Reset the timeout status bit so that the timer
> +        * needs to count down twice again before rebooting */
> +       outw(0x0008, TCO1_STS(p));      /* write 1 to clear bit */
> +
>         /* Reload the timer by writing to the TCO Timer Counter register */
> -       if (p->iTCO_version >= 2) {
> +       if (p->iTCO_version >= 2)
>                 outw(0x01, TCO_RLD(p));
> -       } else if (p->iTCO_version == 1) {
> -               /* Reset the timeout status bit so that the timer
> -                * needs to count down twice again before rebooting */
> -               outw(0x0008, TCO1_STS(p));      /* write 1 to clear bit */
> -
> +       else if (p->iTCO_version == 1)
>                 outb(0x01, TCO_RLD(p));
> -       }
>
>         spin_unlock(&p->io_lock);
>         return 0;
> @@ -302,11 +301,8 @@ static int iTCO_wdt_set_timeout(struct watchdog_device *wd_dev, unsigned int t)
>         unsigned char val8;
>         unsigned int tmrval;
>
> -       tmrval = seconds_to_ticks(p, t);
> -
> -       /* For TCO v1 the timer counts down twice before rebooting */
> -       if (p->iTCO_version == 1)
> -               tmrval /= 2;
> +       /* The timer counts down twice before rebooting */
> +       tmrval = seconds_to_ticks(p, t) / 2;
>
>         /* from the specs: */
>         /* "Values of 0h-3h are ignored and should not be attempted" */
> @@ -359,8 +355,9 @@ static unsigned int iTCO_wdt_get_timeleft(struct watchdog_device *wd_dev)
>                 spin_lock(&p->io_lock);
>                 val16 = inw(TCO_RLD(p));
>                 val16 &= 0x3ff;
> +               if (!(inw(TCO1_STS(p)) & 0x0008))
> +                       val16 += (inw(TCOv2_TMR(p)) & 0x3ff);

>                 spin_unlock(&p->io_lock);
> -
>                 time_left = ticks_to_seconds(p, val16);

This change does not belong to the patch.

>         } else if (p->iTCO_version == 1) {
>                 spin_lock(&p->io_lock);
> --
> 2.9.3
>



-- 
With Best Regards,
Andy Shevchenko

      reply	other threads:[~2017-04-05 10:32 UTC|newest]

Thread overview: 2+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2017-04-05  9:03 [PATCH] iTCO_wdt: all versions count down twice Paolo Bonzini
2017-04-05 10:31 ` Andy Shevchenko [this message]

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=CAHp75VcjjhWzyRu_-qMBE0wW4q38iqxF3jHULi-gOrS4cG+V_w@mail.gmail.com \
    --to=andy.shevchenko@gmail.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-watchdog@vger.kernel.org \
    --cc=linux@roeck-us.net \
    --cc=pbonzini@redhat.com \
    --cc=wim@iguana.be \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.