Hi All, I am getting following message if i post to b.a.t.m.a.n@ lists.open-mesh.org. So I am mailing to this group. Our wifi does not support adhoc mode. I am trying batman-adv setup on managed mode. Can anybody tell me the settings fro batman-adv in managed mode/STA mode? Regards, Rudresh On 10 April 2015 at 23:16, Linus Lüssing wrote: > Let's use these new, neat helpers. > > Signed-off-by: Linus Lüssing > --- > net/bridge/br_multicast.c | 28 ++++------------------------ > 1 file changed, 4 insertions(+), 24 deletions(-) > > diff --git a/net/bridge/br_multicast.c b/net/bridge/br_multicast.c > index 4b6722f..b52f4cb 100644 > --- a/net/bridge/br_multicast.c > +++ b/net/bridge/br_multicast.c > @@ -1610,16 +1610,8 @@ static int br_multicast_ipv4_rcv(struct net_bridge > *br, > if (!pskb_may_pull(skb2, sizeof(*ih))) > goto out; > > - switch (skb2->ip_summed) { > - case CHECKSUM_COMPLETE: > - if (!csum_fold(skb2->csum)) > - break; > - /* fall through */ > - case CHECKSUM_NONE: > - skb2->csum = 0; > - if (skb_checksum_complete(skb2)) > - goto out; > - } > + if (skb_checksum_simple_validate(skb2)) > + goto out; > > err = 0; > > @@ -1737,20 +1729,8 @@ static int br_multicast_ipv6_rcv(struct net_bridge > *br, > > ip6h = ipv6_hdr(skb2); > > - switch (skb2->ip_summed) { > - case CHECKSUM_COMPLETE: > - if (!csum_ipv6_magic(&ip6h->saddr, &ip6h->daddr, skb2->len, > - IPPROTO_ICMPV6, skb2->csum)) > - break; > - /*FALLTHROUGH*/ > - case CHECKSUM_NONE: > - skb2->csum = ~csum_unfold(csum_ipv6_magic(&ip6h->saddr, > - &ip6h->daddr, > - skb2->len, > - IPPROTO_ICMPV6, > 0)); > - if (__skb_checksum_complete(skb2)) > - goto out; > - } > + if (skb_checksum_validate(skb2, IPPROTO_ICMPV6, > ip6_compute_pseudo)) > + goto out; > > err = 0; > > -- > 1.7.10.4 > >