Hi,

We have followed below steps to add a minnow board: 

1)Board bring up
     -Added a jenkins job to build an image using yocto project.
     -For this, Python 3.5 or greater version is required.

2) Automate the hard reboot
     -Minnow board is connected to a usb relay.
     -Hard reboot is done by jenkins job.

3)Adding a board
     -minnow.board file is added. 

4) Adding a toolchain
      -sdk toolchain has been installed inside a container.
      -To access the toolchain ".toolchain" is added.


 Attached writeup explains steps to build an image for the minnow board using the yocto project. It briefly explains steps to add the SDK toolchain for minnow board.

Thanks and regards,
Pooja More




This message contains confidential information and is intended only for the individual(s) named. If you are not the intended recipient, you are notified that disclosing, copying, distributing or taking any action in reliance on the contents of this mail and attached file/s is strictly prohibited. Please notify the sender immediately and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secured or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission.