From mboxrd@z Thu Jan  1 00:00:00 1970
From: Fabio Estevam <festevam@gmail.com>
Date: Fri, 17 Jan 2020 14:18:55 -0300
Subject: question: mx7ulp - LDO_ENABLED_MODE
In-Reply-To: <20200117165104.GC3054@trex>
References: <20200116203000.GA21781@trex>
 <CAOMZO5BREwtHueLTzgZ=rsr+odxBVZDtfYf-F_KYi+HqK3pDjg@mail.gmail.com>
 <20200117165104.GC3054@trex>
Message-ID: <CAOMZO5CgMpGJsCGdgKi1CCFP4oOaF6XHW0=+cWn5qaB5uU-NoA@mail.gmail.com>
List-Id: <u-boot.lists.denx.de>
MIME-Version: 1.0
Content-Type: text/plain; charset="windows-1252"
Content-Transfer-Encoding: quoted-printable
To: u-boot@lists.denx.de

On Fri, Jan 17, 2020 at 1:51 PM Jorge Ramirez-Ortiz, Gmail
<jorge.ramirez.ortiz@gmail.com> wrote:

> btw was checking the TRM manual (Chapter 28, PMC - page 1172)
>
> [..]
> PMC1 power mode[LDOVL] fields don=E2=80=99t necessarily satisfy the opera=
tion voltage levels
> required by the system. Such operation voltage requirements can be found =
on i.MX 7ULP
> Data Sheet. In this sense, no power transition should be performed before=
 ensuring the
> mentioned register fields are matching the required operation voltage lev=
els expressed on
> the data sheet.
>
> =3D>  0.95V in the ldt_init function, is it in the data sheet?
> I just cant find that particular document

Yes, please take a look at https://www.nxp.com/docs/en/data-sheet/IMX7ULPCE=
C.pdf

(Table 5 - Search for PMC1_STOP[LDOVL] where it shows 0.95V as the
typical value)