From mboxrd@z Thu Jan 1 00:00:00 1970 From: Simon Glass Date: Fri, 14 Sep 2018 12:53:31 +0200 Subject: [U-Boot] [PATCH v3 6/8] powerpc: mpc85xx: Use binman to embed dtb inside U-Boot In-Reply-To: <1535990712-8359-7-git-send-email-jagdish.gediya@nxp.com> References: <1535990712-8359-1-git-send-email-jagdish.gediya@nxp.com> <1535990712-8359-7-git-send-email-jagdish.gediya@nxp.com> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 3 September 2018 at 18:05, Jagdish Gediya wrote: > Below is the sequence to embed dtb inside U-Boot, > 1. Remove bootpg and resetvec section if needed > 2. Append dtb > 3. Append bootpg and resetvec section back if removed in step 1 > > Above procedure is required only when CONFIG_MPC85xx and > CONFIG_OF_SEPARATE are defined. > > Add new config CONFIG_MPC85XX_HAVE_RESET_VECTOR to indicate that > image has resetvec section. Step 1 and step 3 described above are > required only if this config is y. > > Signed-off-by: Jagdish Gediya > --- > Changes for v2: > - Don't change the generic target > - Add new config option to use binman Where is that config option? I don't see it in this patch. > > Changes for v3: > - Commit message change('u-boot' -> 'U-Boot') > > Makefile | 23 ++++++++++++++++++++++- > arch/powerpc/cpu/mpc85xx/Kconfig | 4 ++++ > 2 files changed, 26 insertions(+), 1 deletion(-) Reviewed-by: Simon Glass