[U-Boot] [PATCH] ARM: crt0: Pass malloc base address

[Simon Glass <sjg@chromium.org>]

Hi Fabio,

On 11 November 2015 at 13:23, Fabio Estevam <festevam@gmail.com> wrote:
> From: Fabio Estevam <fabio.estevam@freescale.com>
>
> Commit 5ba534d247d418 ("arm: Switch 32-bit ARM to using generic global_data
> setup") causes malloc() to fail in SPL.
>
> The reason is that the GD_MALLOC_BASE is not passed anymore.
>
> Restore the code that passes malloc base so that we can have
> malloc working in SPL code again.
>
> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
> ---
>  arch/arm/lib/crt0.S | 4 ++++
>  1 file changed, 4 insertions(+)
>
> diff --git a/arch/arm/lib/crt0.S b/arch/arm/lib/crt0.S
> index 80548eb..d620126 100644
> --- a/arch/arm/lib/crt0.S
> +++ b/arch/arm/lib/crt0.S
> @@ -87,6 +87,10 @@ ENTRY(_main)
>         mov     sp, r0
>
>         mov     r0, #0
> +#if defined(CONFIG_SYS_MALLOC_F_LEN)
> +       sub     sp, sp, #CONFIG_SYS_MALLOC_F_LEN
> +       str     sp, [r9, #GD_MALLOC_BASE]
> +#endif
>         bl      board_init_f
>
>  #if ! defined(CONFIG_SPL_BUILD)
> --
> 1.9.1
>

Thanks for digging into this. But this should be set up in board_init_f_mem():

#if defined(CONFIG_SYS_MALLOC_F) && \
   (!defined(CONFIG_SPL_BUILD) || !defined(CONFIG_SYS_SPL_MALLOC_START))
   top -= CONFIG_SYS_MALLOC_F_LEN;
   gd->malloc_base = top;
#endif

Is it possible that the #ifdef logic is wrong for your board?

Regardds,
Simon