Hi Khem Replacing  IMAGE_INSTALL += "i2c-tools vim" withIMAGE_INSTALL_append = " i2c-tools vim" in my local.conf solve the problem. More than half of the sources were rebuild. Thanks a lot. Now I found also the info in the manual "Using IMAGE_INSTALL with the += operator from the /conf/local.conf file or from within an image recipe is not recommended as it can cause ordering issues." Regards, Wojciech  -- Securely sent with Tutanota. Get your own encrypted, ad-free mailbox: https://tutanota.com Dec 17, 2019, 05:48 by raj.khem@gmail.com: > On Mon, Dec 16, 2019 at 1:56 PM wrote: > >> >> Problem with rootfs boot on my raspberrypi. >> >> Hi >> I am building simple image for my raspbery pi 3 A+ and connect to the pi via USB-UART converter and see the following in the console >> ... >> [ 2.071459] Run /bin/init as init process >> [ 2.076507] Run /bin/sh as init process >> sh: cannot set terminal process group (-1): Inappropriate ioctl for device >> sh: no job control in this shell >> sh-4.4# >> >> >> >> I build with the "bitbake core-image-base" and tried to run it on rpi 3A+, 3B, 3B+ and the problem is always the same it cannot switch to the rootfs on the sd card it seem like it stack at initramfs or some middle ground. >> >> I burn the *.rpi-sdimg image to SD card with dd from my Ubuntu16.04 host machine. >> I tried with two branches thud and warrior and the problem is exactly the same. >> The strange thing is that in this initramfs there are no tools like find grep modprobe etc. but I see my extra tools "i2c-tools vim" >> >> Here is my local.conf adjustments: >> MACHINE ?= "raspberrypi3" >> ENABLE_I2C = "1" >> ENABLE_UART = "1" >> IMAGE_INSTALL += "i2c-tools vim" >> > > Can you turn this into > IMAGE_INSTALL_append = " i2c-tools vim" > >> >> and the bblayer.conf >> BBLAYERS ?= " \ >> /media/dave/Develop/yoctopi/warrior/sources/poky/meta \ >> /media/dave/Develop/yoctopi/warrior/sources/poky/meta-poky \ >> /media/dave/Develop/yoctopi/warrior/sources/poky/meta-yocto-bsp \ >> /media/dave/Develop/yoctopi/warrior/sources/meta-openembedded/meta-oe \ >> /media/dave/Develop/yoctopi/warrior/sources/meta-raspberrypi \ >> " >> >> I tried also to build with the deprecated image "bitbake rpi-basic-image" but then I did not get my extra tools "i2c-tools vim". >> >> Anyone have any idea what can be wrong with my approach ? >> >> Regards, >> >> Wojciech >> >> >> -=-=-=-=-=-=-=-=-=-=-=- >> Links: You receive all messages sent to this group. >> >> View/Reply Online (#47702): https://lists.yoctoproject.org/g/yocto/message/47702 >> Mute This Topic: https://lists.yoctoproject.org/mt/68744766/1997914 >> Mute #raspberrypi: https://lists.yoctoproject.org/mk?hashtag=raspberrypi&subid=6692173 >> Group Owner: yocto+owner@lists.yoctoproject.org >> Unsubscribe: https://lists.yoctoproject.org/g/yocto/unsub [raj.khem@gmail.com] >> -=-=-=-=-=-=-=-=-=-=-=- >>