From mboxrd@z Thu Jan 1 00:00:00 1970 From: kazuhiro3.hayashi@toshiba.co.jp (kazuhiro3.hayashi at toshiba.co.jp) Date: Mon, 11 Nov 2019 06:18:31 +0000 Subject: [cip-dev] [isar-cip-core PATCH 3/4] hihope-rzg2m: Add board support In-Reply-To: References: <20191106124439.10532-1-Quirin.Gylstorff@siemens.com> <20191106124439.10532-4-Quirin.Gylstorff@siemens.com> <66a2849e-bbf8-7e67-0da3-490b052f18cb@siemens.com> Message-ID: To: cip-dev@lists.cip-project.org List-Id: cip-dev.lists.cip-project.org Hello Quirin, > On 11/7/19 3:29 AM, kazuhiro3.hayashi at toshiba.co.jp wrote: > > Hello Quirin, > > > >> I will look into it using the cip-kernel-config instead of using copies > >> in isar. > > > > Are you planning to "fetch" required config(s) for each target from cip-kernel-config? > > or, keep copies of the configs in isar-cip-core then synchronize them at the specific point? > > I try to fetch the configuration for each target from cip-kernel-config. Thanks! As the first step, I will do the same way in deby to use existing configs in cip-kernel-config. Best regards, Kazu > Currently I need to patch the config as Isar doesn't allow setting > CONFIG_LOCALVERSION in the kernel configuration. > > > > > Deby also has its own kernel configs (arm64 defconfig + Tiny hihope-rzg2m.config) > > for HiHope RZG2M: > > > https://gitlab.com/cip-project/cip-core/deby/blob/cip-core-buster/meta-hihope-rzg2m/recipes-kernel/linux/linux-ba > se_git.bbappend > > but they also should be replaced by the common kernel configs in CIP. > > As the first step, I would provide configs by the same way as isar-cip-core. > > > > Best regards, > > Kazu > > > > > > Quirin