From mboxrd@z Thu Jan 1 00:00:00 1970 From: Jerry Huang Date: Tue, 26 Nov 2019 08:15:29 +0000 Subject: [Buildroot] [EXT] Re: [PATCH v2 08/10] package/freescale-qoriq/fsl-qoriq-rcw:Enable IIC5_PMUX and CLK_OUT_PMUX for GPIO In-Reply-To: <20191125231342.714eadfb@windsurf> References: <20191121102324.35225-1-jerry.huang@nxp.com> <20191121102324.35225-9-jerry.huang@nxp.com> <20191125231342.714eadfb@windsurf> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: buildroot@busybox.net Best Regards Jerry Huang > -----Original Message----- > From: Thomas Petazzoni > Sent: Tuesday, November 26, 2019 6:14 AM > To: Jerry Huang > Cc: buildroot at busybox.net; michael at walle.cc; matthew.weber at collins.com; > geomatsi at gmail.com > Subject: [EXT] Re: [Buildroot] [PATCH v2 08/10] > package/freescale-qoriq/fsl-qoriq-rcw:Enable IIC5_PMUX and CLK_OUT_PMUX > for GPIO > > Caution: EXT Email > > On Thu, 21 Nov 2019 18:23:22 +0800 > Changming Huang wrote: > > > From: Jerry Huang > > > > Because GPIO is used as interrupt for eNETC PHY and Micro-bus, > > IIC5_PMUX and CLK_OUT_PMUX are enabled for GPIO. > > > > Signed-off-by: Jerry Huang > > What is the upstream status of those patches? Will NXP merge them in the rcw > project, and will make them available as part of a future RCW release ? These two patches are for SD and eMMC boot, which are not pushed to upsteam. If I use xSPI boot, the RCW setting is correct without these two patches. As you mentioned in the reply of patch 10/10, if just one defconfig is pushed to buildroot, I can remove these two patches. > Thanks, > > Thomas > -- > Thomas Petazzoni, CTO, Bootlin > Embedded Linux and Kernel engineering > https://eur01.safelinks.protection.outlook.com/?url=https%3A%2F%2Fbootlin.c > om&data=02%7C01%7Cjerry.huang%40nxp.com%7C10089319800b42973 > 24908d771f4bd40%7C686ea1d3bc2b4c6fa92cd99c5c301635%7C0%7C0%7C637 > 103168375059339&sdata=j0xbOhtQRtJfFqW%2BefA1mhEvCczUGIdbk0M > COPIzg0k%3D&reserved=0