On Tue, Feb 16, 2021 at 09:13:54AM +0100, Oleksij Rempel wrote:
> changes v6:
> - rename it to interrupt-counter

Hi Oleksij,

Sorry to nitpick again, I think "irq-counter" as Jonathan suggested in
an earlier review would be a better name afterall. Would you be able to
rename this driver to use that name instead?

Sincerely,

William Breathitt Gray

> - driver fixes
> - device tree fixes
> 
> changes v5:
> - rename it to event counter, since it support different event sources
> - make it work with gpio-only or irq-only configuration
> - update yaml binding
> 
> changes v4:
> - use IRQ_NOAUTOEN to not enable IRQ by default
> - rename gpio_ from name pattern and make this driver work any IRQ
>   source.
> 
> changes v3:
> - convert counter to atomic_t
> 
> changes v2:
> - add commas
> - avoid possible unhandled interrupts in the enable path
> - do not use of_ specific gpio functions
> 
> Add support for GPIO based pulse counter. For now it can only count
> pulses. With counter char device support, we will be able to attach
> timestamps and measure actual pulse frequency.
> 
> Never the less, it is better to mainline this driver now (before chardev
> patches go mainline), to provide developers additional use case for the counter
> framework with chardev support.
> 
> Oleksij Rempel (2):
>   dt-bindings: counter: add event-counter binding
>   counter: add IRQ or GPIO based event counter
> 
>  .../bindings/counter/interrupt-counter.yaml   |  62 +++++
>  MAINTAINERS                                   |   7 +
>  drivers/counter/Kconfig                       |  10 +
>  drivers/counter/Makefile                      |   1 +
>  drivers/counter/interrupt-cnt.c               | 249 ++++++++++++++++++
>  5 files changed, 329 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/counter/interrupt-counter.yaml
>  create mode 100644 drivers/counter/interrupt-cnt.c
> 
> -- 
> 2.29.2
>