Comment # 127
on bug 94990
from fariouche@yahoo.fr
Hi,
I finally tried the 4.12.2 kernel, and in my case it does not fully work :(
I can see a working console, but:
- only on my first monitor (DVI)
- no x11 (I can see a brief display of xfce4 but immediately turns black and no
more display, even if I return to the console.)
I think I'm facing 2 different issues. One is about detecting my second monitor
(a 4K LG 31MU97 plugged on DP-0 (this display is maybe a bit slow to probe))
The log shows a lot of error concerning this monitor...
But I do not see anything on my third output too (HDMI, this is an av receiver,
with a full HD tv). No error at all for this one, even the resolution is probed
correctly by xorg.
The kernel log shows an EDID error for the LG monitor...
[ 1.065917] ACPI: Power Button [PWRF]
[ 1.066154] Monitor-Mwait will be used to enter C-1 state
[ 1.066158] Monitor-Mwait will be used to enter C-2 state
[ 1.066161] Monitor-Mwait will be used to enter C-3 state
[ 1.067170] ioatdma: Intel(R) QuickData Technology Driver 4.00
[ 1.067386] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
[ 1.067877] Non-volatile memory driver v1.3
[ 1.068132] Linux agpgart interface v0.103
[ 1.068546] nouveau 0000:03:00.0: NVIDIA GM204 (124020a1)
[ 1.158533] nouveau 0000:03:00.0: bios: version 84.04.36.00.0b
[ 1.158944] nouveau 0000:03:00.0: disp: dcb 15 type 8 unknown
[ 1.159616] nouveau 0000:03:00.0: fb: 4096 MiB GDDR5
[ 1.159794] nouveau 0000:03:00.0: bus: MMIO write of 80000159 FAULT at
10eb14 [ IBUS ]
[ 1.168074] [TTM] Zone kernel: Available graphics memory: 8214682 kiB
[ 1.168244] [TTM] Zone dma32: Available graphics memory: 2097152 kiB
[ 1.168410] [TTM] Initializing pool allocator
[ 1.168576] [TTM] Initializing DMA pool allocator
[ 1.168830] nouveau 0000:03:00.0: DRM: VRAM: 4096 MiB
[ 1.168995] nouveau 0000:03:00.0: DRM: GART: 1048576 MiB
[ 1.169161] nouveau 0000:03:00.0: DRM: TMDS table version 2.0
[ 1.169327] nouveau 0000:03:00.0: DRM: DCB version 4.1
[ 1.169492] nouveau 0000:03:00.0: DRM: DCB outp 00: 01000f02 00020030
[ 1.169666] nouveau 0000:03:00.0: DRM: DCB outp 01: 02000f00 00000000
[ 1.169838] nouveau 0000:03:00.0: DRM: DCB outp 02: 02811f76 04400020
[ 1.170004] nouveau 0000:03:00.0: DRM: DCB outp 03: 02011f72 00020020
[ 1.170170] nouveau 0000:03:00.0: DRM: DCB outp 04: 04822f86 04400010
[ 1.170337] nouveau 0000:03:00.0: DRM: DCB outp 05: 04022f82 00020010
[ 1.170504] nouveau 0000:03:00.0: DRM: DCB outp 06: 04833f96 04400020
[ 1.170678] nouveau 0000:03:00.0: DRM: DCB outp 07: 04033f92 00020020
[ 1.170848] nouveau 0000:03:00.0: DRM: DCB outp 08: 02044f62 00020010
[ 1.171015] nouveau 0000:03:00.0: DRM: DCB outp 15: 01df5ff8 00000000
[ 1.171181] nouveau 0000:03:00.0: DRM: DCB conn 00: 00001030
[ 1.171347] nouveau 0000:03:00.0: DRM: DCB conn 01: 00020146
[ 1.171511] nouveau 0000:03:00.0: DRM: DCB conn 02: 01000246
[ 1.171684] nouveau 0000:03:00.0: DRM: DCB conn 03: 02000346
[ 1.171853] nouveau 0000:03:00.0: DRM: DCB conn 04: 00010461
[ 1.172018] nouveau 0000:03:00.0: DRM: DCB conn 05: 00000570
[ 1.172183] nouveau 0000:03:00.0: DRM: Pointer to flat panel table invalid
[ 1.214711] random: fast init done
[ 1.233460] nouveau 0000:03:00.0: DRM: unknown connector type 70
[ 1.233662] nouveau 0000:03:00.0: DRM: failed to create encoder 1/8/0: -19
[ 1.233834] nouveau 0000:03:00.0: DRM: Unknown-1 has no encoders, removing
[ 1.234034] [drm] Supports vblank timestamp caching Rev 2 (21.10.2013).
[ 1.234207] [drm] Driver supports precise vblank timestamp query.
[ 1.276832] nouveau 0000:03:00.0: hwmon_device_register() is deprecated.
Please convert the driver to use hwmon_device_register_with_info().
[ 1.343188] nouveau 0000:03:00.0: DRM: MM: using COPY for buffer copies
[ 1.434201] nouveau 0000:03:00.0: DP-1: EDID is invalid:
[ 1.434384] [00] BAD 03 12 71 45 10 04 03 01 00 23 09 07 07 83 01 00
[ 1.434568] [00] BAD 00 02 3a 80 18 71 38 2d 40 58 2c 45 00 b8 6f 21
[ 1.434759] [00] BAD 00 00 1e 00 00 00 00 00 00 00 00 00 00 00 00 00
[ 1.434939] [00] BAD 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
[ 1.435121] [00] BAD 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
[ 1.435301] [00] BAD 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
[ 1.435482] [00] BAD 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
[ 1.435670] [00] BAD 00 00 00 00 00 00 00 00 00 00 00 00 00 00 44 00
[ 1.435855] nouveau 0000:03:00.0: DRM: DDC responded, but no EDID for DP-1
[ 1.706882] nouveau 0000:03:00.0: DRM: allocated 1920x1200 fb: 0x60000, bo
ffff88041cec5800
[ 1.707396] fbcon: nouveaufb (fb0) is primary device
[ 1.798548] nouveau 0000:03:00.0: DRM: DDC responded, but no EDID for DP-1
[ 2.068735] tsc: Refined TSC clocksource calibration: 3197.726 MHz
[ 2.068740] clocksource: tsc: mask: 0xffffffffffffffff max_cycles:
0x2e17e64edfb, max_idle_ns: 440795351804 ns
[ 2.090622] nouveau 0000:03:00.0: DRM: DDC responded, but no EDID for DP-1
[ 2.481844] Console: switching to colour frame buffer device 200x67
[ 2.501851] nouveau 0000:03:00.0: fb0: nouveaufb frame buffer device
[ 2.501864] [drm] Initialized nouveau 1.3.1 20120801 for 0000:03:00.0 on
minor 0
When switching to x11, I see the following errors:
Jul 22 12:15:40 Quazar kernel: nouveau 0000:03:00.0: DRM: DDC responded, but no
EDID for DP-1
Jul 22 12:15:40 Quazar kernel: nouveau 0000:03:00.0: DRM: DDC responded, but no
EDID for DP-1
Jul 22 12:15:40 Quazar kernel: nouveau 0000:03:00.0: DRM: DDC responded, but no
EDID for DP-1
Jul 22 12:15:42 Quazar kernel: nouveau 0000:03:00.0: DRM: DDC responded, but no
EDID for DP-1
Jul 22 12:15:42 Quazar kernel: nouveau 0000:03:00.0: DRM: DDC responded, but no
EDID for DP-1
Jul 22 12:15:42 Quazar dbus[4361]: [system] Activating service
name='org.freedesktop.UPower' (using servicehelper)
Jul 22 12:15:42 Quazar dbus[4361]: [system] Successfully activated service
'org.freedesktop.UPower'
Jul 22 12:15:42 Quazar polkitd[4433]: Registered Authentication Agent for
unix-session:/org/freedesktop/ConsoleKit/Session1 (system bus name :1.8
[/usr/libexec/polkit-gnome-authentication-agent-1], object path
/org/gnome/PolicyKit1/AuthenticationAgent, locale en_US.utf8)
Jul 22 12:15:42 Quazar kernel: nouveau 0000:03:00.0: bus: MMIO read of 00000000
FAULT at 61c814 [ IBUS ]
Jul 22 12:15:42 Quazar kernel: nouveau 0000:03:00.0: disp: intr24 80000000
Jul 22 12:15:42 Quazar kernel: nouveau 0000:03:00.0: bus: MMIO read of 00000000
FAULT at 61c930 [ IBUS ]
Jul 22 12:15:42 Quazar kernel: nouveau 0000:03:00.0: bus: MMIO read of 00000000
FAULT at 61c9b0 [ IBUS ]
.......
Jul 22 12:15:42 Quazar kernel: nouveau 0000:03:00.0: bus: MMIO read of 00000000
FAULT at 61c9bc [ IBUS ]
Jul 22 12:15:42 Quazar kernel: nouveau 0000:03:00.0: disp: outp 02:0006:0f82:
link training failed
Jul 22 12:15:42 Quazar kernel: nouveau 0000:03:00.0: bus: MMIO read of 00000000
FAULT at 61c92c [ IBUS ]
Jul 22 12:15:44 Quazar kernel: nouveau 0000:03:00.0: DRM: EVO timeout
Jul 22 12:15:46 Quazar kernel: nouveau 0000:03:00.0: DRM: EVO timeout
Jul 22 12:15:48 Quazar kernel: nouveau 0000:03:00.0: DRM: base-0: timeout
Jul 22 12:15:48 Quazar kernel: nouveau 0000:03:00.0: bus: MMIO read of 00000000
FAULT at 690400 [ IBUS TIMEOUT ]
Jul 22 12:15:50 Quazar kernel: nouveau 0000:03:00.0: DRM: EVO timeout
Jul 22 12:15:52 Quazar kernel: nouveau 0000:03:00.0: DRM: base-1: timeout
Jul 22 12:16:05 Quazar kernel: nouveau 0000:03:00.0: DRM: base-0: timeout
Jul 22 12:16:05 Quazar kernel: nouveau 0000:03:00.0: DRM: base-1: timeout
Jul 22 12:16:05 Quazar kernel: nouveau 0000:03:00.0: DRM: base-0: timeout
Jul 22 12:16:05 Quazar kernel: nouveau 0000:03:00.0: DRM: base-1: timeout
Jul 22 12:16:05 Quazar kernel: nouveau 0000:03:00.0: DRM: base-0: timeout
Jul 22 12:16:05 Quazar kernel: nouveau 0000:03:00.0: DRM: base-1: timeout
I can attach all the relevant logs.
Any idea? Maybe this belongs to an other bug?