From mboxrd@z Thu Jan 1 00:00:00 1970 From: Patrice CHOTARD Date: Mon, 27 Apr 2020 12:06:48 +0000 Subject: [PATCH] regulator: fix: enable gpio when requested In-Reply-To: <20200427090947.75951-1-kettenis@openbsd.org> References: <20200427090947.75951-1-kettenis@openbsd.org> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Hi Mark On 4/27/20 11:09 AM, Mark Kettenis wrote: > The fix in commit b7adcdd073c0 has the side-effect that the regulator > will be disabled when requesting the relevant gpio in > regulator_common_ofdata_to_platdata() and enabled in > regulator_pre_probe() when the regulator was already enabled. > This leads to a short interruption in the 3.3V power to the PCIe > slot on the firefly-rk3399 which makes an ADATA SX8000NP NVMe SSD > unhappy. > > Fix this by setting the GPIOD_IS_OUT_ACTIVE flag again when the > 'regulator-boot-on' property is set, but check for this property > explicitly instead of relying on the "boot_on" member of > the uclass platdata. > > Signed-off-by: Mark Kettenis > --- > drivers/power/regulator/regulator-uclass.c | 3 --- > drivers/power/regulator/regulator_common.c | 2 ++ > 2 files changed, 2 insertions(+), 3 deletions(-) > > diff --git a/drivers/power/regulator/regulator-uclass.c b/drivers/power/regulator/regulator-uclass.c > index c9d26344d7..90961de95c 100644 > --- a/drivers/power/regulator/regulator-uclass.c > +++ b/drivers/power/regulator/regulator-uclass.c > @@ -464,9 +464,6 @@ static int regulator_pre_probe(struct udevice *dev) > (uc_pdata->min_uA == uc_pdata->max_uA)) > uc_pdata->flags |= REGULATOR_FLAG_AUTOSET_UA; > > - if (uc_pdata->boot_on) > - regulator_set_enable(dev, uc_pdata->boot_on); > - > return 0; > } > > diff --git a/drivers/power/regulator/regulator_common.c b/drivers/power/regulator/regulator_common.c > index 33b73b7c2f..bc13b88476 100644 > --- a/drivers/power/regulator/regulator_common.c > +++ b/drivers/power/regulator/regulator_common.c > @@ -17,6 +17,8 @@ int regulator_common_ofdata_to_platdata(struct udevice *dev, > > if (!dev_read_bool(dev, "enable-active-high")) > flags |= GPIOD_ACTIVE_LOW; > + if (dev_read_bool(dev, "regulator-boot-on")) > + flags |= GPIOD_IS_OUT_ACTIVE; > > /* Get optional enable GPIO desc */ > gpio = &dev_pdata->gpio; Tested on STM32MP1 EV1 and DK2 boards in basic and trusted mode Tested-by: Patrice Chotard Thanks