From mboxrd@z Thu Jan 1 00:00:00 1970 From: Marek Vasut Date: Tue, 6 Jun 2017 10:03:29 +0200 Subject: [U-Boot] [PATCH v8 5/7] drivers: Enable FPGA driver build on SPL In-Reply-To: <1496730959-13353-6-git-send-email-tien.fong.chee@intel.com> References: <1496730959-13353-1-git-send-email-tien.fong.chee@intel.com> <1496730959-13353-6-git-send-email-tien.fong.chee@intel.com> Message-ID: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On 06/06/2017 08:35 AM, tien.fong.chee at intel.com wrote: > From: Tien Fong Chee > > Enable FPGA driver build for SPL because FPGA driver is needed for SPL > to configure and getting DDR up before loading U-boot into DDR and > booting from there. > > FPGA driver build on SPL must be enabled 1st before applying next patch to > avoid build failed, because fpga_manager which would be moved to > drivers/fpga by next patch are required in SPL. > > Signed-off-by: Tien Fong Chee You should probably swap this and 4/5 ? > --- > drivers/Makefile | 1 + > 1 file changed, 1 insertion(+) > > diff --git a/drivers/Makefile b/drivers/Makefile > index 64c39d3..4478212 100644 > --- a/drivers/Makefile > +++ b/drivers/Makefile > @@ -48,6 +48,7 @@ obj-$(CONFIG_OMAP_USB_PHY) += usb/phy/ > obj-$(CONFIG_SPL_SATA_SUPPORT) += block/ > obj-$(CONFIG_SPL_USB_HOST_SUPPORT) += block/ > obj-$(CONFIG_SPL_MMC_SUPPORT) += block/ > +obj-$(CONFIG_SPL_FPGA_SUPPORT) += fpga/ > endif > > ifdef CONFIG_TPL_BUILD > -- Best regards, Marek Vasut