[U-Boot] [PATCH 00/10] mx7: add dt support for Colibri iMX7S/iMX7D

[Stefano Babic <sbabic@denx.de>]

On 03/10/2016 21:59, Stefan Agner wrote:
> Hi Stefano,
> 
> On 2016-08-26 06:25, Stefano Babic wrote:
>> Hi Stefan,
>>
>> On 26/07/2016 08:22, Stefan Agner wrote:
>>> From: Stefan Agner <stefan.agner@toradex.com>
>>>
>>> This patchset adds device tree support for Colibri iMX7S/iMX7D.
>>> It is the first device tree enabled board for any i.MX 7 SoC
>>> hence the patchset adds some common infrastructure:
>>> - Add device tree support for serial_mxc.
>>> - imx7.dtsi - I descided to leave the s/d suffix since the SoCs
>>>   are very similar and boards will likely use runtime detection
>>>   to distinguish the two available SoCs.
>>> - The pinmux file imx7d-pinfunc.h is taken from the Kernel and
>>>   stored in the same place
>>>
>>> Otherwise the conversion is quite straightforward and simplified
>>> the board code somewhat. Two patches enhance the board support
>>> with PMIC support, which has been the driver for this conversion.
>>>
>>> --
>>
>>
>> Applied (whole series) to u-boot-imx, thanks !
> 
> I did not see this patch set in 2016.11-rc1, will it still make it
> there?

I check it - I have also a list of patches to be merged, I will go in
and pick them.

Regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================