On 8/25/2016 12:53 AM, David Miller wrote: > From: Salil Mehta > Date: Wed, 24 Aug 2016 04:44:48 +0800 > >> This patch is meant to add support of ACPI to the Hisilicon RoCE driver. >> Following changes have been made in the driver(s): >> >> Patch 1/2: HNS Ethernet Driver: changes to support ACPI have been done in >> the RoCE reset function part of the HNS ethernet driver. Earlier it only >> supported DT/syscon. >> >> Patch 2/2. HNS RoCE driver: changes done in RoCE driver are meant to detect >> the type and then either use DT specific or ACPI spcific functions. Where >> ever possible, this patch tries to make use of "Unified Device Property >> Interface" APIs to support both DT and ACPI through single interface. >> >> NOTE 1: ACPI changes done in both of the drivers depend upon the ACPI Table >> (DSDT and IORT tables) changes part of UEFI/BIOS. These changes are NOT >> part of this patch-set. >> NOTE 2: Reset function in Patch 1/2 depends upon the reset function added in >> ACPI tables(basically DSDT table) part of the UEFI/BIOS. Again, this >> change is NOT reflected in this patch-set. > > I can't apply this series to my tree because the hns infiniband driver > doesn't exist in it. > No. This probably needs to go through my tree. Although with all of the requirements, I'm a bit concerned about those being present elsewhere. -- Doug Ledford GPG Key ID: 0E572FDD