ath10k.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: "Rafael J. Wysocki" <rafael@kernel.org>
To: Kalle Valo <kvalo@codeaurora.org>
Cc: Paul McKenney <paulmck@kernel.org>,
	Linux PM <linux-pm@vger.kernel.org>,
	Peter Zijlstra <peterz@infradead.org>,
	Frederic Weisbecker <frederic@kernel.org>,
	"Rafael J. Wysocki" <rjw@rjwysocki.net>,
	LKML <linux-kernel@vger.kernel.org>,
	ath10k@lists.infradead.org,
	Johannes Berg <johannes@sipsolutions.net>
Subject: Re: WARNING: suspicious RCU usage (5.11.0-rc7+ #1812 Tainted: G)
Date: Tue, 9 Feb 2021 18:44:21 +0100	[thread overview]
Message-ID: <CAJZ5v0iX0Bn7qjTB6S8exox_NYujAupUy4XkJAyFVNDjvnnZXg@mail.gmail.com> (raw)
In-Reply-To: <877dnhv4lg.fsf@codeaurora.org>

On Tue, Feb 9, 2021 at 12:57 PM Kalle Valo <kvalo@codeaurora.org> wrote:
>
> + ath10k list
>
> Peter Zijlstra <peterz@infradead.org> writes:
>
> > On Mon, Feb 08, 2021 at 08:04:27PM +0100, Rafael J. Wysocki wrote:
> >> Hi Peter & Paul,
> >>
> >> The traces below are present in the boot dmesg log on my Dell XPS13 9360.
> >>
> >> I haven't had the time to look into this in detail yet, but here it goes in
> >> case you know what's going on already.
> >>
> >> Cheers!
> >>
> >>
> >> [   86.762542] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
> >>
> >> [   86.764298] =============================
> >> [   86.764300] WARNING: suspicious RCU usage
> >> [   86.764302] 5.11.0-rc7+ #1812 Tainted: G          I
> >> [   86.764305] -----------------------------
> >> [ 86.764307]
> >> /scratch/rafael/work/linux-pm/include/linux/rhashtable.h:594
> >> suspicious rcu_dereference_check() usage!
> >> [   86.764309]
> >>                other info that might help us debug this:
> >>
> >> [   86.764311]
> >>                rcu_scheduler_active = 2, debug_locks = 1
> >> [   86.764313] no locks held by swapper/1/0.
> >> [   86.764316]
> >>                stack backtrace:
> >> [ 86.764318] CPU: 1 PID: 0 Comm: swapper/1 Tainted: G I 5.11.0-rc7+
> >> #1812
> >> [   86.764321] Hardware name: Dell Inc. XPS 13 9360/, BIOS 1.3.5 05/08/2017
> >> [   86.764323] Call Trace:
> >> [   86.764325]  <IRQ>
> >> [   86.764328]  dump_stack+0x77/0x97
> >> [   86.764336]  ieee80211_find_sta_by_ifaddr+0x218/0x2e0 [mac80211]
> >> [ 86.764380] ?
> >> ath10k_wmi_tlv_op_pull_mgmt_tx_bundle_compl_ev+0xe0/0xe0
> >> [ath10k_core]
> >> [   86.764399]  ath10k_wmi_tlv_parse_peer_stats_info+0x2a/0x70 [ath10k_core]
> >> [   86.764411]  ath10k_wmi_tlv_iter+0x56/0xd0 [ath10k_core]
> >> [   86.764424]  ath10k_wmi_tlv_op_rx+0x75a/0xa30 [ath10k_core]
> >> [   86.764438]  ath10k_htc_rx_completion_handler+0xe8/0x120 [ath10k_core]
> >> [   86.764452]  ? ath10k_htc_process_trailer+0x290/0x290 [ath10k_core]
> >> [   86.764462]  ath10k_pci_process_rx_cb+0x117/0x180 [ath10k_pci]
> >> [   86.764472]  ? ath10k_ce_per_engine_service+0x4c/0x80 [ath10k_core]
> >> [   86.764490]  ? _raw_spin_unlock_irqrestore+0x47/0x60
> >> [   86.764504]  ath10k_ce_per_engine_service+0x5d/0x80 [ath10k_core]
> >> [   86.764524]  ath10k_ce_per_engine_service_any+0x6a/0xa0 [ath10k_core]
> >> [   86.764543]  ath10k_pci_napi_poll+0x44/0x110 [ath10k_pci]
> >> [   86.764552]  net_rx_action+0x15d/0x4e0
> >> [   86.764570]  __do_softirq+0xeb/0x492
> >> [   86.764583]  ? handle_fasteoi_irq+0x150/0x150
> >> [   86.764591]  asm_call_irq_on_stack+0x12/0x20
> >> [   86.764598]  </IRQ>
> >> [   86.764602]  do_softirq_own_stack+0x81/0xa0
> >> [   86.764609]  irq_exit_rcu+0xcd/0xe0
> >> [   86.764614]  common_interrupt+0xfe/0x230
> >> [   86.764623]  asm_common_interrupt+0x1e/0x40
> >> [   86.764626] RIP: 0010:cpuidle_enter_state+0x109/0x4a0
> >> [ 86.764631] Code: 02 00 00 31 ff e8 b7 40 8e ff 45 84 ff 74 12 9c
> >> 58 f6 c4 02 0f 85 10 03 00 00 31 ff e8 70 42 96 ff e8 bb a2 9d ff fb
> >> 45 85 f6 <0f> 88 12 01 00 00 49 63 d6 4c 2b 24 24 48 8d 04 52 48 8d
> >> 04 82 49
> >> [   86.764634] RSP: 0018:ffffc900000e3e80 EFLAGS: 00000202
> >> [   86.764638] RAX: 00000000000e8d89 RBX: 0000000000000002 RCX: 0000000000000000
> >> [   86.764641] RDX: 0000000000000000 RSI: ffffffff82392561 RDI: ffffffff82344126
> >> [   86.764643] RBP: ffffe8ffffc93300 R08: 0000000000000001 R09: 0000000000000001
> >> [   86.764645] R10: ffffc900000e3e60 R11: 0000000000000002 R12: 00000014338d5797
> >> [   86.764647] R13: ffffffff827e6d60 R14: 0000000000000002 R15: 0000000000000000
> >> [   86.764667]  cpuidle_enter+0x29/0x40
> >> [   86.764672]  do_idle+0x22d/0x2b0
> >> [   86.764682]  cpu_startup_entry+0x19/0x20
> >> [   86.764686]  start_secondary+0x125/0x160
> >> [   86.764691]  secondary_startup_64_no_verify+0xb0/0xbb
> >>
> >
> > AFAICT that's a simple 'use RCU without holding rcu_read_lock' warning.
> > I've not dug through ath10k to see who should be doing rcu_read_lock,
> > but the few places I did look at don't seem to have changed recently.
>
> Just this morning I applied a patch which should fix this:
>
> https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=ath-next&id=2615e3cdbd9c0e864f5906279c952a309871d225
>
> Please let me know if it fixes the issue.

The traces are gone after applying this patch, so it does help:

Tested-by: Rafael J. Wysocki <rafael@kernel.org>

_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k

  reply	other threads:[~2021-02-09 17:45 UTC|newest]

Thread overview: 3+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
     [not found] <2578278.ATerS0GEoy@kreacher>
     [not found] ` <YCJyJgEeiQqBRgzL@hirez.programming.kicks-ass.net>
2021-02-09 11:54   ` Kalle Valo
2021-02-09 17:44     ` Rafael J. Wysocki [this message]
2021-02-10  5:18       ` Kalle Valo

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=CAJZ5v0iX0Bn7qjTB6S8exox_NYujAupUy4XkJAyFVNDjvnnZXg@mail.gmail.com \
    --to=rafael@kernel.org \
    --cc=ath10k@lists.infradead.org \
    --cc=frederic@kernel.org \
    --cc=johannes@sipsolutions.net \
    --cc=kvalo@codeaurora.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-pm@vger.kernel.org \
    --cc=paulmck@kernel.org \
    --cc=peterz@infradead.org \
    --cc=rjw@rjwysocki.net \
    --subject='Re: WARNING: suspicious RCU usage (5.11.0-rc7+ #1812 Tainted: G)' \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).