Re: [PATCH 5/4] dt-bindings: display: bridge: thc63lvd1024: Document dual-output mode

[Jacopo Mondi <jacopo@jmondi.org>]

Hi Laurent,

On Thu, May 14, 2020 at 02:21:27AM +0300, Laurent Pinchart wrote:
> The DT binding support both dual-input and dual-output mode, but only
> dual-input is documented. Document dual-output mode.
>
> Suggested-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
> Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>

Thanks
Acked-by: Jacopo Mondi <jacopo@jmondi.org>


> ---
>  .../display/bridge/thine,thc63lvd1024.yaml       | 16 +++++++++++-----
>  1 file changed, 11 insertions(+), 5 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.yaml b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.yaml
> index 469ac4a34273..fedd3460d6f6 100644
> --- a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.yaml
> +++ b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.yaml
> @@ -30,11 +30,17 @@ properties:
>        This device has four video ports. Their connections are modeled using the
>        OF graph bindings specified in Documentation/devicetree/bindings/graph.txt.
>
> -      The device can operate in single-link mode or dual-link mode. In
> -      single-link mode, all pixels are received on port@0, and port@1 shall not
> -      contain any endpoint. In dual-link mode, even-numbered pixels are
> -      received on port@0 and odd-numbered pixels on port@1, and both port@0 and
> -      port@1 shall contain endpoints.
> +      The device can operate in single or dual input and output modes.
> +
> +      When operating in single input mode, all pixels are received on port@0,
> +      and port@1 shall not contain any endpoint. In dual input mode,
> +      even-numbered pixels are received on port@0 and odd-numbered pixels on
> +      port@1, and both port@0 and port@1 shall contain endpoints.
> +
> +      When operating in single output mode all pixels are output from the first
> +      CMOS/TTL port and port@3 shall not contain any endpoint. In dual output
> +      mode pixels are output from both CMOS/TTL ports and both port@2 and
> +      port@3 shall contain endpoints.
>
>      properties:
>        '#address-cells':
> --
> Regards,
>
> Laurent Pinchart
>
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel