On Thu, May 28, 2020 at 05:47:41PM +0100, Emil Velikov wrote: > On Tue, 5 May 2020 at 17:05, Emil Velikov wrote: > > > > Currently the function heap allocates when we have any payload. Where in > > many case the payload is 1 byte - ouch. > > > > From casual observation, vast majority of the payloads are smaller than > > 8 bytes - so use a stack array tx[8] to avoid the senseless kmalloc and > > kfree dance. > > > > Cc: Jani Nikula > > Cc: Thierry Reding > > Signed-off-by: Emil Velikov > > --- > > drivers/gpu/drm/drm_mipi_dsi.c | 20 ++++++++++---------- > > 1 file changed, 10 insertions(+), 10 deletions(-) > > > > diff --git a/drivers/gpu/drm/drm_mipi_dsi.c b/drivers/gpu/drm/drm_mipi_dsi.c > > index 55531895dde6..b96d5b4629d7 100644 > > --- a/drivers/gpu/drm/drm_mipi_dsi.c > > +++ b/drivers/gpu/drm/drm_mipi_dsi.c > > @@ -748,26 +748,26 @@ ssize_t mipi_dsi_dcs_write(struct mipi_dsi_device *dsi, u8 cmd, > > { > > ssize_t err; > > size_t size; > > + u8 stack_tx[8]; > > u8 *tx; > > > > - if (len > 0) { > > - size = 1 + len; > > - > > + size = 1 + len; > > + if (len > ARRAY_SIZE(stack_tx) - 1) { > > tx = kmalloc(size, GFP_KERNEL); > > if (!tx) > > return -ENOMEM; > > - > > - /* concatenate the DCS command byte and the payload */ > > - tx[0] = cmd; > > - memcpy(&tx[1], data, len); > > } else { > > - tx = &cmd; > > - size = 1; > > + tx = stack_tx; > > } > > > > + /* concatenate the DCS command byte and the payload */ > > + tx[0] = cmd; > > + if (data) > > + memcpy(&tx[1], data, len); > > + > > err = mipi_dsi_dcs_write_buffer(dsi, tx, size); > > > > - if (len > 0) > > + if (tx != stack_tx) > > kfree(tx); > > > > return err; > > -- > > Thierry, others - humble ping. > Can you check through the series? I don't see patch 2 of this series anywhere? Did it fall victim to some filter? Thierry