Linux-ACPI Archive on lore.kernel.org
 help / color / Atom feed
From: Sakari Ailus <sakari.ailus@linux.intel.com>
To: linux-i2c@vger.kernel.org
Cc: Wolfram Sang <wsa@the-dreams.de>,
	"Rafael J. Wysocki" <rafael@kernel.org>,
	linux-acpi@vger.kernel.org, Bingbu Cao <bingbu.cao@intel.com>,
	linux-media@vger.kernel.org,
	Chiranjeevi Rapolu <chiranjeevi.rapolu@intel.com>,
	Hyungwoo Yang <hyungwoo.yang@intel.com>,
	Bartosz Golaszewski <bgolaszewski@baylibre.com>,
	Arnd Bergmann <arnd@arndb.de>,
	linux-kernel@vger.kernel.org,
	Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
	rajmohan.mani@intel.com, Tomasz Figa <tfiga@chromium.org>,
	"Qiu, Tian Shu" <tian.shu.qiu@intel.com>
Subject: [PATCH v6 5/6] at24: Support probing while off
Date: Wed, 26 Aug 2020 14:54:31 +0300
Message-ID: <20200826115432.6103-6-sakari.ailus@linux.intel.com> (raw)
In-Reply-To: <20200826115432.6103-1-sakari.ailus@linux.intel.com>

In certain use cases (where the chip is part of a camera module, and the
camera module is wired together with a camera privacy LED), powering on
the device during probe is undesirable. Add support for the at24 to
execute probe while being powered off. For this to happen, a hint in form
of a device property is required from the firmware.

Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
---
 drivers/misc/eeprom/at24.c | 43 +++++++++++++++++++++++---------------
 1 file changed, 26 insertions(+), 17 deletions(-)

diff --git a/drivers/misc/eeprom/at24.c b/drivers/misc/eeprom/at24.c
index 2591c21b2b5d8..a343e55e41126 100644
--- a/drivers/misc/eeprom/at24.c
+++ b/drivers/misc/eeprom/at24.c
@@ -561,6 +561,7 @@ static int at24_probe(struct i2c_client *client)
 	bool i2c_fn_i2c, i2c_fn_block;
 	unsigned int i, num_addresses;
 	struct at24_data *at24;
+	bool low_power;
 	struct regmap *regmap;
 	bool writable;
 	u8 test_byte;
@@ -698,25 +699,30 @@ static int at24_probe(struct i2c_client *client)
 
 	i2c_set_clientdata(client, at24);
 
-	err = regulator_enable(at24->vcc_reg);
-	if (err) {
-		dev_err(dev, "Failed to enable vcc regulator\n");
-		return err;
-	}
+	low_power = acpi_dev_state_low_power(&client->dev);
+	if (!low_power) {
+		err = regulator_enable(at24->vcc_reg);
+		if (err) {
+			dev_err(dev, "Failed to enable vcc regulator\n");
+			return err;
+		}
 
-	/* enable runtime pm */
-	pm_runtime_set_active(dev);
+		pm_runtime_set_active(dev);
+	}
 	pm_runtime_enable(dev);
 
 	/*
-	 * Perform a one-byte test read to verify that the
-	 * chip is functional.
+	 * Perform a one-byte test read to verify that the chip is functional,
+	 * unless powering on the device is to be avoided during probe (i.e.
+	 * it's powered off right now).
 	 */
-	err = at24_read(at24, 0, &test_byte, 1);
-	if (err) {
-		pm_runtime_disable(dev);
-		regulator_disable(at24->vcc_reg);
-		return -ENODEV;
+	if (!low_power) {
+		err = at24_read(at24, 0, &test_byte, 1);
+		if (err) {
+			pm_runtime_disable(dev);
+			regulator_disable(at24->vcc_reg);
+			return -ENODEV;
+		}
 	}
 
 	pm_runtime_idle(dev);
@@ -736,9 +742,11 @@ static int at24_remove(struct i2c_client *client)
 	struct at24_data *at24 = i2c_get_clientdata(client);
 
 	pm_runtime_disable(&client->dev);
-	if (!pm_runtime_status_suspended(&client->dev))
-		regulator_disable(at24->vcc_reg);
-	pm_runtime_set_suspended(&client->dev);
+	if (!acpi_dev_state_low_power(&client->dev)) {
+		if (!pm_runtime_status_suspended(&client->dev))
+			regulator_disable(at24->vcc_reg);
+		pm_runtime_set_suspended(&client->dev);
+	}
 
 	return 0;
 }
@@ -775,6 +783,7 @@ static struct i2c_driver at24_driver = {
 	.probe_new = at24_probe,
 	.remove = at24_remove,
 	.id_table = at24_ids,
+	.flags = I2C_DRV_FL_ALLOW_LOW_POWER_PROBE,
 };
 
 static int __init at24_init(void)
-- 
2.20.1


  parent reply index

Thread overview: 16+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-08-26 11:54 [PATCH v6 0/6] Support running driver's probe for a device powered off Sakari Ailus
2020-08-26 11:54 ` [PATCH v6 1/6] i2c: Allow an ACPI driver to manage the device's power state during probe Sakari Ailus
2020-08-28  8:38   ` Wolfram Sang
2020-08-31  8:23     ` Sakari Ailus
2020-08-31  9:31       ` Wolfram Sang
2020-08-31  9:54         ` Sakari Ailus
2020-08-31 10:00   ` Wolfram Sang
2020-08-31 17:05     ` Sakari Ailus
2020-08-26 11:54 ` [PATCH v6 2/6] ACPI: Add a convenience function to tell a device is in low power state Sakari Ailus
2020-08-26 11:54 ` [PATCH v6 3/6] ov5670: Support probe whilst the device is in a " Sakari Ailus
2020-08-26 11:54 ` [PATCH v6 4/6] media: i2c: imx319: Support probe while the device is off Sakari Ailus
2020-08-26 11:54 ` Sakari Ailus [this message]
2020-08-26 11:54 ` [PATCH v6 6/6] Documentation: ACPI: Document allow-low-power-probe _DSD property Sakari Ailus
2020-08-26 18:06   ` Randy Dunlap
2020-08-27 13:28     ` Sakari Ailus
2020-09-01 20:28       ` Sakari Ailus

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200826115432.6103-6-sakari.ailus@linux.intel.com \
    --to=sakari.ailus@linux.intel.com \
    --cc=arnd@arndb.de \
    --cc=bgolaszewski@baylibre.com \
    --cc=bingbu.cao@intel.com \
    --cc=chiranjeevi.rapolu@intel.com \
    --cc=gregkh@linuxfoundation.org \
    --cc=hyungwoo.yang@intel.com \
    --cc=linux-acpi@vger.kernel.org \
    --cc=linux-i2c@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-media@vger.kernel.org \
    --cc=rafael@kernel.org \
    --cc=rajmohan.mani@intel.com \
    --cc=tfiga@chromium.org \
    --cc=tian.shu.qiu@intel.com \
    --cc=wsa@the-dreams.de \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-ACPI Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-acpi/0 linux-acpi/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-acpi linux-acpi/ https://lore.kernel.org/linux-acpi \
		linux-acpi@vger.kernel.org
	public-inbox-index linux-acpi

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-acpi


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git