Linux-ACPI Archive on lore.kernel.org
 help / color / Atom feed
From: Ben Widawsky <ben.widawsky@intel.com>
To: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Cc: linux-cxl@vger.kernel.org, linux-pci@vger.kernel.org,
	linux-acpi@vger.kernel.org, ira.weiny@intel.com,
	vishal.l.verma@intel.com, alison.schofield@intel.com,
	dan.j.williams@intel.com, linux-kernel@vger.kernel.org
Subject: Re: [PATCH 4/7] cxl/mem: Get rid of @cxlm.base
Date: Tue, 13 Apr 2021 09:17:26 -0700
Message-ID: <20210413161726.tz7rg46krrekk3lp@intel.com> (raw)
In-Reply-To: <20210408182635.00003997@Huawei.com>

On 21-04-08 18:26:35, Jonathan Cameron wrote:
> On Wed, 7 Apr 2021 15:26:22 -0700
> Ben Widawsky <ben.widawsky@intel.com> wrote:
> 
> > @cxlm.base only existed to support holding the base found in the
> > register block mapping code, and pass it along to the register setup
> > code. Now that the register setup function has all logic around managing
> > the registers, from DVSEC to iomapping up to populating our CXL specific
> > information, it is easy to turn the @base values into local variables
> > and remove them from our device driver state.
> > 
> > Signed-off-by: Ben Widawsky <ben.widawsky@intel.com>
> 
> Patch is basically fine, but I do wonder if you could avoid the
> nasty casting in and out of __iomem in the error paths.
> 
> It's a common enough idiom though so I'm not htat fussed.
> 
> Acked-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
> 
> > ---
> >  drivers/cxl/mem.c | 24 +++++++++++-------------
> >  drivers/cxl/mem.h |  2 --
> >  2 files changed, 11 insertions(+), 15 deletions(-)
> > 
> > diff --git a/drivers/cxl/mem.c b/drivers/cxl/mem.c
> > index 04b4f7445083..60b95c524c3e 100644
> > --- a/drivers/cxl/mem.c
> > +++ b/drivers/cxl/mem.c
> > @@ -922,11 +922,10 @@ static struct cxl_mem *cxl_mem_create(struct pci_dev *pdev)
> >  	return cxlm;
> >  }
> >  
> > -static int cxl_mem_map_regblock(struct cxl_mem *cxlm, u32 reg_lo, u32 reg_hi)
> > +static void __iomem *cxl_mem_map_regblock(struct cxl_mem *cxlm, u32 reg_lo, u32 reg_hi)
> >  {
> >  	struct pci_dev *pdev = cxlm->pdev;
> >  	struct device *dev = &pdev->dev;
> > -	void __iomem *regs;
> >  	u64 offset;
> >  	u8 bar;
> >  	int rc;
> > @@ -938,20 +937,18 @@ static int cxl_mem_map_regblock(struct cxl_mem *cxlm, u32 reg_lo, u32 reg_hi)
> >  	if (pci_resource_len(pdev, bar) < offset) {
> >  		dev_err(dev, "BAR%d: %pr: too small (offset: %#llx)\n", bar,
> >  			&pdev->resource[bar], (unsigned long long)offset);
> > -		return -ENXIO;
> > +		return (void __iomem *)ERR_PTR(-ENXIO);
> >  	}
> >  
> >  	rc = pcim_iomap_regions(pdev, BIT(bar), pci_name(pdev));
> >  	if (rc) {
> >  		dev_err(dev, "failed to map registers\n");
> > -		return rc;
> > +		return (void __iomem *)ERR_PTR(rc);
> 
> The casting is fairly horrible, perhaps just pass in
> a void __iomem ** and pass base back through that?
> 

TIL: IOMEM_ERR_PTR. Would that suffice?

> >  	}
> > -	regs = pcim_iomap_table(pdev)[bar];
> > -
> > -	cxlm->base = regs + offset;
> >  
> >  	dev_dbg(dev, "Mapped CXL Memory Device resource\n");
> > -	return 0;
> > +
> > +	return pcim_iomap_table(pdev)[bar] + offset;
> >  }
> >  
> >  static int cxl_mem_dvsec(struct pci_dev *pdev, int dvsec)
> > @@ -993,7 +990,8 @@ static int cxl_mem_setup_regs(struct cxl_mem *cxlm)
> >  	struct pci_dev *pdev = cxlm->pdev;
> >  	struct device *dev = &pdev->dev;
> >  	u32 regloc_size, regblocks;
> > -	int rc, regloc, i;
> > +	void __iomem *base;
> > +	int regloc, i;
> >  
> >  	regloc = cxl_mem_dvsec(pdev, PCI_DVSEC_ID_CXL_REGLOC_OFFSET);
> >  	if (!regloc) {
> > @@ -1019,9 +1017,9 @@ static int cxl_mem_setup_regs(struct cxl_mem *cxlm)
> >  		reg_type = FIELD_GET(CXL_REGLOC_RBI_MASK, reg_lo);
> >  
> >  		if (reg_type == CXL_REGLOC_RBI_MEMDEV) {
> > -			rc = cxl_mem_map_regblock(cxlm, reg_lo, reg_hi);
> > -			if (rc)
> > -				return rc;
> > +			base = cxl_mem_map_regblock(cxlm, reg_lo, reg_hi);
> > +			if (IS_ERR(base))
> > +				return PTR_ERR(base);
> >  			break;
> >  		}
> >  	}
> > @@ -1031,7 +1029,7 @@ static int cxl_mem_setup_regs(struct cxl_mem *cxlm)
> >  		return -ENXIO;
> >  	}
> >  
> > -	cxl_setup_device_regs(dev, cxlm->base, &regs->device_regs);
> > +	cxl_setup_device_regs(dev, base, &regs->device_regs);
> >  
> >  	if (!regs->status || !regs->mbox || !regs->memdev) {
> >  		dev_err(dev, "registers not found: %s%s%s\n",
> > diff --git a/drivers/cxl/mem.h b/drivers/cxl/mem.h
> > index 8bad7166adba..bfcfef461b16 100644
> > --- a/drivers/cxl/mem.h
> > +++ b/drivers/cxl/mem.h
> > @@ -49,7 +49,6 @@ struct cxl_memdev {
> >  /**
> >   * struct cxl_mem - A CXL memory device
> >   * @pdev: The PCI device associated with this CXL device.
> > - * @base: IO mappings to the device's MMIO
> >   * @cxlmd: Logical memory device chardev / interface
> >   * @regs: Parsed register blocks
> >   * @payload_size: Size of space for payload
> > @@ -62,7 +61,6 @@ struct cxl_memdev {
> >   */
> >  struct cxl_mem {
> >  	struct pci_dev *pdev;
> > -	void __iomem *base;
> >  	struct cxl_memdev *cxlmd;
> >  
> >  	struct cxl_regs regs;
> 

  reply index

Thread overview: 22+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-04-07 22:26 [PATCH 0/7] Enumerate HDM Decoder registers Ben Widawsky
2021-04-07 22:26 ` [PATCH 1/7] cxl/mem: Use dev instead of pdev->dev Ben Widawsky
2021-04-08 17:08   ` Jonathan Cameron
2021-04-07 22:26 ` [PATCH 2/7] cxl/mem: Split creation from mapping in probe Ben Widawsky
2021-04-08 17:13   ` Jonathan Cameron
2021-04-07 22:26 ` [PATCH 3/7] cxl/mem: Move register locator logic into reg setup Ben Widawsky
2021-04-08 17:27   ` Jonathan Cameron
2021-04-07 22:26 ` [PATCH 4/7] cxl/mem: Get rid of @cxlm.base Ben Widawsky
2021-04-08 17:26   ` Jonathan Cameron
2021-04-13 16:17     ` Ben Widawsky [this message]
2021-04-14  9:24       ` Jonathan Cameron
2021-05-20 21:29       ` [PATCH v2 " Ben Widawsky
2021-04-07 22:26 ` [PATCH 5/7] cxl/mem: Move device register setup Ben Widawsky
2021-04-08 17:28   ` Jonathan Cameron
2021-04-07 22:26 ` [PATCH 6/7] cxl/mem: Create a helper to setup device regs Ben Widawsky
2021-04-08 17:33   ` Jonathan Cameron
2021-04-15 22:54   ` Dan Williams
2021-04-07 22:26 ` [PATCH 7/7] cxl: Add HDM decoder capbilities Ben Widawsky
2021-04-08 17:57   ` Jonathan Cameron
2021-04-15 23:27   ` Dan Williams
2021-04-15 23:50     ` Ben Widawsky
2021-04-16  0:25       ` Dan Williams

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20210413161726.tz7rg46krrekk3lp@intel.com \
    --to=ben.widawsky@intel.com \
    --cc=Jonathan.Cameron@huawei.com \
    --cc=alison.schofield@intel.com \
    --cc=dan.j.williams@intel.com \
    --cc=ira.weiny@intel.com \
    --cc=linux-acpi@vger.kernel.org \
    --cc=linux-cxl@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-pci@vger.kernel.org \
    --cc=vishal.l.verma@intel.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-ACPI Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-acpi/0 linux-acpi/git/0.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-acpi linux-acpi/ https://lore.kernel.org/linux-acpi \
		linux-acpi@vger.kernel.org
	public-inbox-index linux-acpi

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.kernel.vger.linux-acpi


AGPL code for this site: git clone https://public-inbox.org/public-inbox.git