Re: [PATCH v3 7/8] arm64: mm: Set ZONE_DMA size based on early IORT scan

From: Nicolas Saenz Julienne <nsaenzjulienne@suse.de>
To: Hanjun Guo <guohanjun@huawei.com>,
	robh+dt@kernel.org, catalin.marinas@arm.com, hch@lst.de,
	ardb@kernel.org, linux-kernel@vger.kernel.org,
	Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>,
	Sudeep Holla <sudeep.holla@arm.com>
Cc: robin.murphy@arm.com, linux-arm-kernel@lists.infradead.org,
	linux-rpi-kernel@lists.infradead.org, jeremy.linton@arm.com,
	iommu@lists.linux-foundation.org, devicetree@vger.kernel.org,
	Anshuman Khandual <anshuman.khandual@arm.com>,
	Will Deacon <will@kernel.org>,
	"Rafael J. Wysocki" <rjw@rjwysocki.net>,
	Len Brown <lenb@kernel.org>,
	linux-acpi@vger.kernel.org
Subject: Re: [PATCH v3 7/8] arm64: mm: Set ZONE_DMA size based on early IORT scan
Date: Thu, 15 Oct 2020 17:15:09 +0200	[thread overview]
Message-ID: <64bbecb547422272417feaff1aa6b3d8c3da1157.camel@suse.de> (raw)
In-Reply-To: <1a3df60a-4568-cb72-db62-36127d0ffb7e@huawei.com>

[-- Attachment #1: Type: text/plain, Size: 2194 bytes --]

On Thu, 2020-10-15 at 22:26 +0800, Hanjun Guo wrote:
> On 2020/10/15 3:12, Nicolas Saenz Julienne wrote:
> > From: Ard Biesheuvel <ardb@kernel.org>
> > 
> > We recently introduced a 1 GB sized ZONE_DMA to cater for platforms
> > incorporating masters that can address less than 32 bits of DMA, in
> > particular the Raspberry Pi 4, which has 4 or 8 GB of DRAM, but has
> > peripherals that can only address up to 1 GB (and its PCIe host
> > bridge can only access the bottom 3 GB)
> > 
> > Instructing the DMA layer about these limitations is straight-forward,
> > even though we had to fix some issues regarding memory limits set in
> > the IORT for named components, and regarding the handling of ACPI _DMA
> > methods. However, the DMA layer also needs to be able to allocate
> > memory that is guaranteed to meet those DMA constraints, for bounce
> > buffering as well as allocating the backing for consistent mappings.
> > 
> > This is why the 1 GB ZONE_DMA was introduced recently. Unfortunately,
> > it turns out the having a 1 GB ZONE_DMA as well as a ZONE_DMA32 causes
> > problems with kdump, and potentially in other places where allocations
> > cannot cross zone boundaries. Therefore, we should avoid having two
> > separate DMA zones when possible.
> > 
> > So let's do an early scan of the IORT, and only create the ZONE_DMA
> > if we encounter any devices that need it. This puts the burden on
> > the firmware to describe such limitations in the IORT, which may be
> > redundant (and less precise) if _DMA methods are also being provided.
> > However, it should be noted that this situation is highly unusual for
> > arm64 ACPI machines. Also, the DMA subsystem still gives precedence to
> > the _DMA method if implemented, and so we will not lose the ability to
> > perform streaming DMA outside the ZONE_DMA if the _DMA method permits
> > it.
> 
> Sorry, I'm still a little bit confused. With this patch, if we have
> a device which set the right _DMA method (DMA size >= 32), but with the
> wrong DMA size in IORT, we still have the ZONE_DMA created which
> is actually not needed?

Yes, that would be the case.

Regards,
Nicolas

[-- Attachment #2: This is a digitally signed message part --]
[-- Type: application/pgp-signature, Size: 488 bytes --]