From: Jean-Philippe Brucker <jean-philippe@linaro.org>
To: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Cc: joro@8bytes.org, will@kernel.org, lorenzo.pieralisi@arm.com,
robh+dt@kernel.org, guohanjun@huawei.com, sudeep.holla@arm.com,
rjw@rjwysocki.net, lenb@kernel.org, robin.murphy@arm.com,
eric.auger@redhat.com, iommu@lists.linux-foundation.org,
devicetree@vger.kernel.org, linux-acpi@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
linux-accelerators@lists.ozlabs.org, baolu.lu@linux.intel.com,
jacob.jun.pan@linux.intel.com, kevin.tian@intel.com,
vdumpa@nvidia.com, zhangfei.gao@linaro.org,
shameerali.kolothum.thodi@huawei.com, vivek.gautam@arm.com
Subject: Re: [PATCH v10 10/10] iommu/arm-smmu-v3: Add stall support for platform devices
Date: Fri, 22 Jan 2021 09:51:20 +0100 [thread overview]
Message-ID: <YAqSCKeN2o+GsISZ@myrica> (raw)
In-Reply-To: <20210121191236.00000103@Huawei.com>
On Thu, Jan 21, 2021 at 07:12:36PM +0000, Jonathan Cameron wrote:
> > @@ -2502,6 +2647,7 @@ static void arm_smmu_release_device(struct device *dev)
> >
> > master = dev_iommu_priv_get(dev);
> > WARN_ON(arm_smmu_master_sva_enabled(master));
> > + iopf_queue_remove_device(master->smmu->evtq.iopf, dev);
> > arm_smmu_detach_dev(master);
> > arm_smmu_disable_pasid(master);
> > arm_smmu_remove_master(master);
>
> The lack of symmetry here bothers me a bit, but it's already true, so I guess
> this case is fine as well.
Normally the device driver calls iommu_dev_feat_disable(SVA) which does
iopf_queue_remove_device(). This is just a safety net in case the device
gets removed without the driver properly cleaning up (which will WARN as
well)
>
> ...
> >
> > @@ -2785,6 +2946,7 @@ static int arm_smmu_cmdq_init(struct arm_smmu_device *smmu)
> > static int arm_smmu_init_queues(struct arm_smmu_device *smmu)
> > {
> > int ret;
> > + bool sva = smmu->features & ARM_SMMU_FEAT_STALLS;
>
> FEAT_SVA?
Ugh yes, thanks. I left this as a bool instead of moving into the test
below because the PRI patch reuses it, but I think I'll just move it down
when resending.
Thanks,
Jean
>
> >
> > /* cmdq */
> > ret = arm_smmu_init_one_queue(smmu, &smmu->cmdq.q, ARM_SMMU_CMDQ_PROD,
> > @@ -2804,6 +2966,12 @@ static int arm_smmu_init_queues(struct arm_smmu_device *smmu)
> > if (ret)
> > return ret;
> >
> > + if (sva && smmu->features & ARM_SMMU_FEAT_STALLS) {
>
> Isn't this checking same thing twice?
>
> > + smmu->evtq.iopf = iopf_queue_alloc(dev_name(smmu->dev));
> > + if (!smmu->evtq.iopf)
> > + return -ENOMEM;
> > + }
> > +
> > /* priq */
> > if (!(smmu->features & ARM_SMMU_FEAT_PRI))
> > return 0;
> > @@ -3718,6 +3886,7 @@ static int arm_smmu_device_remove(struct platform_device *pdev)
> > iommu_device_unregister(&smmu->iommu);
> > iommu_device_sysfs_remove(&smmu->iommu);
> > arm_smmu_device_disable(smmu);
> > + iopf_queue_free(smmu->evtq.iopf);
> >
> > return 0;
> > }
>
next prev parent reply other threads:[~2021-01-22 8:54 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-01-21 12:36 [PATCH v10 00/10] iommu: I/O page faults for SMMUv3 Jean-Philippe Brucker
2021-01-21 12:36 ` [PATCH v10 01/10] iommu: Fix comment for struct iommu_fwspec Jean-Philippe Brucker
2021-01-21 12:36 ` [PATCH v10 02/10] iommu/arm-smmu-v3: Use device properties for pasid-num-bits Jean-Philippe Brucker
2021-01-21 12:36 ` [PATCH v10 03/10] iommu: Separate IOMMU_DEV_FEAT_IOPF from IOMMU_DEV_FEAT_SVA Jean-Philippe Brucker
2021-01-21 12:36 ` [PATCH v10 04/10] iommu/vt-d: Support IOMMU_DEV_FEAT_IOPF Jean-Philippe Brucker
2021-01-22 1:54 ` Lu Baolu
2021-01-21 12:36 ` [PATCH v10 05/10] uacce: Enable IOMMU_DEV_FEAT_IOPF Jean-Philippe Brucker
2021-01-21 12:36 ` [PATCH v10 06/10] iommu: Add a page fault handler Jean-Philippe Brucker
2021-01-21 12:36 ` [PATCH v10 07/10] iommu/arm-smmu-v3: Maintain a SID->device structure Jean-Philippe Brucker
2021-01-22 10:35 ` Auger Eric
2021-01-21 12:36 ` [PATCH v10 08/10] dt-bindings: document stall property for IOMMU masters Jean-Philippe Brucker
2021-01-21 12:36 ` [PATCH v10 09/10] ACPI/IORT: Enable stall support for platform devices Jean-Philippe Brucker
2021-01-21 18:57 ` Jonathan Cameron
2021-01-21 12:36 ` [PATCH v10 10/10] iommu/arm-smmu-v3: Add " Jean-Philippe Brucker
2021-01-21 19:12 ` Jonathan Cameron
2021-01-22 8:51 ` Jean-Philippe Brucker [this message]
2021-01-22 10:58 ` Jonathan Cameron
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=YAqSCKeN2o+GsISZ@myrica \
--to=jean-philippe@linaro.org \
--cc=Jonathan.Cameron@huawei.com \
--cc=baolu.lu@linux.intel.com \
--cc=devicetree@vger.kernel.org \
--cc=eric.auger@redhat.com \
--cc=guohanjun@huawei.com \
--cc=iommu@lists.linux-foundation.org \
--cc=jacob.jun.pan@linux.intel.com \
--cc=joro@8bytes.org \
--cc=kevin.tian@intel.com \
--cc=lenb@kernel.org \
--cc=linux-accelerators@lists.ozlabs.org \
--cc=linux-acpi@vger.kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=lorenzo.pieralisi@arm.com \
--cc=rjw@rjwysocki.net \
--cc=robh+dt@kernel.org \
--cc=robin.murphy@arm.com \
--cc=shameerali.kolothum.thodi@huawei.com \
--cc=sudeep.holla@arm.com \
--cc=vdumpa@nvidia.com \
--cc=vivek.gautam@arm.com \
--cc=will@kernel.org \
--cc=zhangfei.gao@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).