Re: [PATCH 0/8] drm/meson: Add support for HDMI2.0 4k60

[Neil Armstrong <narmstrong@baylibre.com>]

Hi Andrzej, Laurent,

On 15/01/2019 13:33, Neil Armstrong wrote:
> This patchset aims to add support for the following HDMI2.0 4k60 modes:
> - 594Mhz TMDS frequency needing TMDS Scramling and 1/40 rate for RGB/YUV4:4:4
> - 297MHz TMDS frequency with YUV4:2:0 encoding
> 
> The first mode uses the SCDC helpers introduced by intel to :
> - discover where the monitor support SCDC
> - setup the SCDC parameters
> This is implemented in the dw-hdmi bridge driver by handling scrambling
> support during the bridge setup and by exporting an helper for the PHY
> setup to setup the SCDC configuration for the 1/40 TMDS rate.
> This code will only be active if the encoder support a TMDS rate > 340MHz.
> 
> This patch could eventually break support on different SoC when connected
> on a 4k60 monitor with SCDC :
> - i.MX correctly discards pixel clocks > 216MHz
> - R-CAR discards discards pixel clocks > 297MHz since [1]
> - Rockchip discards invalid pixel clocks not in the rockchip_mpll_cfg table
> - sun8i correctly discards pixel clocks > 297MHz on a83t
> - sun8i discards discards pixel clocks > 594Mhz on h6, which is already broken
> 
> First patch should fix support for Allwinner H6.
> 
> The second mode is implemented by added the missing 4:2:0 bypass handling
> in the dw-hdmi bridge driver and adding a "mtmdsclock" separating the
> pixel clock from the tmds clock in the mode setup phase.
> We also enable support for these modes in the connector only if the platform
> glue code explicits the support.

Do you think patches 1-4 could be applied ?

Then we could focus on how we manage the bus format between the encoder
and the bridge ?

Especially patch 5 linked to patch 7.

Will one of you be at FOSDEM 2019 ? we could chat about this.

Following subjects on the table will be :
- HDR metadata transmission aligned with the last patchset sent by intel-gfx
- Colorspace connector property aligned with the last patchset sent by intel-gfx
- HDCP 1.4 and 2.2 handling

Neil

> 
> Only the meson DRM dw_hdmi glue allows ycbcr420 modes, so no breakage
> is expected here.
> 
> The remaining patches adds support for :
> - 1/40 TMDS rate aka DIV40 in the dw-hdmi meson PHY setup
> - 4:2:0 output and clock setup
> 
> The dw-hdmi support re-uses the support done by Rockchip engineers on the
> Linux 4.4 BSP kernel.
> 
> These modes has been validated using a MuxLab HDMI Signal Analyser in
> addition to different UHD TVs supporting full 4k60 or the 4:2:0 variant.
> 
> Changes since RFC v2 at [3]:
> - Collected tested-by and reviewed-by tags
> - Changed if condition in "add HDMI div40 TMDS mode"
> - Updated "Add YUV420 output support" with the same if condition
> 
> Changes since RFC v1 at [2]:
> - Fix all comments from Laurent :
> - Add define for HDMI 1.4 max tmds clock and SCDC supported version
> - Call dw_hdmi_set_high_tmds_clock_ratio() in dw_hdmi_phy_enable_powerdown()
> to unbreak Allwinner H6
> - Pass in_t(u8, bytes, SCDC_MIN_SOURCE_VERSION) as SCDC version
> - Finally add comments for SCDC and Scrambling process
> 
> [1] https://patchwork.freedesktop.org/patch/263616/
> [2] https://patchwork.freedesktop.org/series/52950/#rev1
> [3] https://patchwork.freedesktop.org/series/52950/#rev2
> 
> Neil Armstrong (7):
>   drm/bridge: dw-hdmi: Add SCDC and TMDS Scrambling support
>   drm/meson: add HDMI div40 TMDS mode
>   drm/meson: add support for HDMI2.0 2160p modes
>   drm/bridge: dw-hdmi: add support for YUV420 output
>   drm/bridge: dw-hdmi: allow ycbcr420 modes for >= 0x200a
>   drm/meson: Add YUV420 output support
>   drm/meson: Output in YUV444 if sink supports it
> 
> Zheng Yang (1):
>   drm/bridge: dw-hdmi: support dynamically get input/out color info
> 
>  drivers/gpu/drm/bridge/synopsys/dw-hdmi.c | 182 +++++++++++++++++++---
>  drivers/gpu/drm/bridge/synopsys/dw-hdmi.h |   1 +
>  drivers/gpu/drm/meson/meson_dw_hdmi.c     | 128 ++++++++++++---
>  drivers/gpu/drm/meson/meson_vclk.c        |  93 ++++++++---
>  drivers/gpu/drm/meson/meson_vclk.h        |   7 +-
>  drivers/gpu/drm/meson/meson_venc.c        |   8 +-
>  drivers/gpu/drm/meson/meson_venc.h        |  11 ++
>  drivers/gpu/drm/meson/meson_venc_cvbs.c   |   3 +-
>  include/drm/bridge/dw_hdmi.h              |   7 +
>  9 files changed, 374 insertions(+), 66 deletions(-)
> 


_______________________________________________
linux-amlogic mailing list
linux-amlogic@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-amlogic