From mboxrd@z Thu Jan 1 00:00:00 1970 From: rogerq@ti.com (Roger Quadros) Date: Wed, 20 Mar 2013 17:44:48 +0200 Subject: [PATCH v4 09/21] ARM: OMAP3: cm-t35: Adapt to ehci-omap changes In-Reply-To: <1363794300-31526-1-git-send-email-rogerq@ti.com> References: <1363794300-31526-1-git-send-email-rogerq@ti.com> Message-ID: <1363794300-31526-10-git-send-email-rogerq@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Use usbhs_init_phys() to register the PHY's RESET regulators and the NOP PHY devices. Signed-off-by: Roger Quadros --- arch/arm/mach-omap2/board-cm-t35.c | 20 ++++++++++++++------ 1 files changed, 14 insertions(+), 6 deletions(-) diff --git a/arch/arm/mach-omap2/board-cm-t35.c b/arch/arm/mach-omap2/board-cm-t35.c index af2bb21..7fda3f5 100644 --- a/arch/arm/mach-omap2/board-cm-t35.c +++ b/arch/arm/mach-omap2/board-cm-t35.c @@ -419,15 +419,22 @@ static struct omap2_hsmmc_info mmc[] = { {} /* Terminator */ }; +static struct usbhs_phy_data phy_data[] __initdata = { + { + .port = 1, + .reset_gpio = OMAP_MAX_GPIO_LINES + 6, + .vcc_gpio = -EINVAL, + }, + { + .port = 2, + .reset_gpio = OMAP_MAX_GPIO_LINES + 7, + .vcc_gpio = -EINVAL, + }, +}; + static struct usbhs_omap_platform_data usbhs_bdata __initdata = { .port_mode[0] = OMAP_EHCI_PORT_MODE_PHY, .port_mode[1] = OMAP_EHCI_PORT_MODE_PHY, - .port_mode[2] = OMAP_USBHS_PORT_MODE_UNUSED, - - .phy_reset = true, - .reset_gpio_port[0] = OMAP_MAX_GPIO_LINES + 6, - .reset_gpio_port[1] = OMAP_MAX_GPIO_LINES + 7, - .reset_gpio_port[2] = -EINVAL }; static void __init cm_t35_init_usbh(void) @@ -444,6 +451,7 @@ static void __init cm_t35_init_usbh(void) msleep(1); } + usbhs_init_phys(phy_data, ARRAY_SIZE(phy_data)); usbhs_init(&usbhs_bdata); } -- 1.7.4.1