From mboxrd@z Thu Jan 1 00:00:00 1970 From: peter.griffin@linaro.org (Peter Griffin) Date: Fri, 5 Sep 2014 18:23:44 +0100 Subject: [PATCH RESEND v5 0/5] Add EHCI and OHCI drivers for STi SoC's Message-ID: <1409937829-23708-1-git-send-email-peter.griffin@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi, As part of the RESEND I've rebased this series on top of 3.17-rc3. I believe all feedback has been addressed. The series was re-worked from v2 onwards to split out the ehci and ohci parts into their own drivers / devices like most other ARM platforms based on feedback from Arnd Bergmann (see here http://www.spinics.net/lists/linux-usb/msg111124.html. The ehci-platform & ohci-platform have been used as a basis for this in case we wish to merge the drivers again in the future. Changes since v4: - Ensure suspend / resume callbacks are wrapped in #ifdef CONFIG_PM_SLEEP as otherwise we will get linker 'unused function' warnings when this option is disabled. - Only declare and reference pm_ops struct if CONFIG_PM_SLEEP is enabled, this saves a few bytes Changes since v3: - Make reset / power, clocks etc non optional dt options to simplify code - Get rid of non DT boot code left over from *hci-platform drivers - Remove DMA mask code - Remove pre_setup func ptr and configure ahb2st bus convertor in ehci_platform_reset - Unabstract and remove usb-st-common.c - Have one kconfig which enables both ehci-st & ohci-st drivers Changes since v2: - Based on Arnd Berghman feedback, split out into 2 devices / drivers - Base drivers oh ehci-platform.c & ohci-platform.c with required extensions to allow possible re-merge in the furture. Changes since v1: - Correct s/OCHI/OHCI/ spelling - Improve kconfig help message - Various formating / spelling nits identified by Lee Jones - Make driver depend on OF & remove node checks in code - Use devm_ioremap_resource - Remove unnecessary header files Peter Griffin (5): usb: host: ehci-st: Add EHCI support for ST STB devices usb: host: ohci-st: Add OHCI driver support for ST STB devices usb: host: ehci-st: Add ehci-st devicetree bindings documentation usb: host: ohci-st: Add ohci-st devicetree bindings documentation MAINTAINERS: Add ehci-st.c and ohci-st.c to ARCH/STI architecture Documentation/devicetree/bindings/usb/ehci-st.txt | 39 +++ Documentation/devicetree/bindings/usb/ohci-st.txt | 37 +++ MAINTAINERS | 2 + drivers/usb/host/Kconfig | 8 + drivers/usb/host/Makefile | 1 + drivers/usb/host/ehci-st.c | 365 ++++++++++++++++++++++ drivers/usb/host/ohci-st.c | 339 ++++++++++++++++++++ drivers/usb/host/usb-st-common.h | 31 ++ 8 files changed, 822 insertions(+) create mode 100644 Documentation/devicetree/bindings/usb/ehci-st.txt create mode 100644 Documentation/devicetree/bindings/usb/ohci-st.txt create mode 100644 drivers/usb/host/ehci-st.c create mode 100644 drivers/usb/host/ohci-st.c create mode 100644 drivers/usb/host/usb-st-common.h -- 1.9.1