From mboxrd@z Thu Jan 1 00:00:00 1970 From: peter.griffin@linaro.org (Peter Griffin) Date: Fri, 5 Sep 2014 18:23:47 +0100 Subject: [PATCH RESEND v5 3/5] usb: host: ehci-st: Add ehci-st devicetree bindings documentation In-Reply-To: <1409937829-23708-1-git-send-email-peter.griffin@linaro.org> References: <1409937829-23708-1-git-send-email-peter.griffin@linaro.org> Message-ID: <1409937829-23708-4-git-send-email-peter.griffin@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org This patch documents the device tree bindings required for the ehci on-chip controller found in ST consumer electronics SoC's. Signed-off-by: Peter Griffin --- Documentation/devicetree/bindings/usb/ehci-st.txt | 39 +++++++++++++++++++++++ 1 file changed, 39 insertions(+) create mode 100644 Documentation/devicetree/bindings/usb/ehci-st.txt diff --git a/Documentation/devicetree/bindings/usb/ehci-st.txt b/Documentation/devicetree/bindings/usb/ehci-st.txt new file mode 100644 index 0000000..fb45fa5 --- /dev/null +++ b/Documentation/devicetree/bindings/usb/ehci-st.txt @@ -0,0 +1,39 @@ +ST USB EHCI controller + +Required properties: + - compatible : must be "st,st-ehci-300x" + - reg : physical base addresses of the controller and length of memory mapped + region + - interrupts : one EHCI interrupt should be described here + - pinctrl-names : a pinctrl state named "default" must be defined + - pinctrl-0 : phandle referencing pin configuration of the USB controller +See: Documentation/devicetree/bindings/pinctrl/pinctrl-binding.txt + - clocks : phandle list of usb clocks + - clock-names : should be "ic" for interconnect clock and "clk48" +See: Documentation/devicetree/bindings/clock/clock-bindings.txt + + - phys : phandle for the PHY device + - phy-names : should be "usb" + - resets : phandle + reset specifier pairs to the powerdown and softreset lines + of the USB IP + - reset-names : should be "power" and "softreset" +See: Documentation/devicetree/bindings/reset/st,sti-powerdown.txt +See: Documentation/devicetree/bindings/reset/reset.txt + +Example: + + ehci1: usb at 0xfe203e00 { + compatible = "st,st-ehci-300x"; + reg = <0xfe203e00 0x100>; + interrupts = ; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_usb1>; + clocks = <&clk_s_a1_ls 0>; + phys = <&usb2_phy>; + phy-names = "usb"; + status = "okay"; + + resets = <&powerdown STIH416_USB1_POWERDOWN>, + <&softreset STIH416_USB1_SOFTRESET>; + reset-names = "power", "softreset"; + }; -- 1.9.1