linux-arm-kernel.lists.infradead.org archive mirror
 help / color / mirror / Atom feed
From: dillon.minfei@gmail.com
To: linus.walleij@linaro.org, broonie@kernel.org
Cc: devicetree@vger.kernel.org, linux-clk@vger.kernel.org,
	linux-kernel@vger.kernel.org, dri-devel@lists.freedesktop.org,
	linux-spi@vger.kernel.org, dillon min <dillon.minfei@gmail.com>,
	linux-stm32@st-md-mailman.stormreply.com,
	linux-arm-kernel@lists.infradead.org
Subject: [PATCH v5 3/8] ARM: dts: stm32: enable ltdc binding with ili9341, gyro l3gd20 on stm32429-disco board
Date: Mon, 25 May 2020 11:45:43 +0800	[thread overview]
Message-ID: <1590378348-8115-4-git-send-email-dillon.minfei@gmail.com> (raw)
In-Reply-To: <1590378348-8115-1-git-send-email-dillon.minfei@gmail.com>

From: dillon min <dillon.minfei@gmail.com>

Enable the ltdc & ili9341, gyro l3gd20 on stm32429-disco board.

Signed-off-by: dillon min <dillon.minfei@gmail.com>
---
 arch/arm/boot/dts/stm32f429-disco.dts | 48 +++++++++++++++++++++++++++++++++++
 1 file changed, 48 insertions(+)

diff --git a/arch/arm/boot/dts/stm32f429-disco.dts b/arch/arm/boot/dts/stm32f429-disco.dts
index 30c0f67..365d16f 100644
--- a/arch/arm/boot/dts/stm32f429-disco.dts
+++ b/arch/arm/boot/dts/stm32f429-disco.dts
@@ -49,6 +49,8 @@
 #include "stm32f429.dtsi"
 #include "stm32f429-pinctrl.dtsi"
 #include <dt-bindings/input/input.h>
+#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/gpio/gpio.h>
 
 / {
 	model = "STMicroelectronics STM32F429i-DISCO board";
@@ -127,3 +129,49 @@
 	pinctrl-names = "default";
 	status = "okay";
 };
+
+&ltdc {
+	status = "okay";
+	pinctrl-0 = <&ltdc_pins_f429_disco>;
+	pinctrl-names = "default";
+
+	port {
+		ltdc_out_rgb: endpoint {
+			remote-endpoint = <&panel_in_rgb>;
+		};
+	};
+};
+
+&spi5 {
+	status = "okay";
+	pinctrl-0 = <&spi5_pins>;
+	pinctrl-names = "default";
+	#address-cells = <1>;
+	#size-cells = <0>;
+	cs-gpios = <&gpioc 1 GPIO_ACTIVE_LOW>, <&gpioc 2 GPIO_ACTIVE_LOW>;
+
+	l3gd20: l3gd20@0 {
+		compatible = "st,l3gd20-gyro";
+		spi-max-frequency = <10000000>;
+		st,drdy-int-pin = <2>;
+		interrupt-parent = <&gpioa>;
+		interrupts = <1 IRQ_TYPE_EDGE_RISING>,
+				<2 IRQ_TYPE_EDGE_RISING>;
+		reg = <0>;
+		status = "okay";
+	};
+
+	display: display@1{
+		/* Connect panel-ilitek-9341 to ltdc */
+		compatible = "st,sf-tc240t-9370-t";
+		reg = <1>;
+		spi-3wire;
+		spi-max-frequency = <10000000>;
+		dc-gpios = <&gpiod 13 0>;
+		port {
+			panel_in_rgb: endpoint {
+			remote-endpoint = <&ltdc_out_rgb>;
+			};
+		};
+	};
+};
-- 
2.7.4


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

  parent reply	other threads:[~2020-05-25  3:47 UTC|newest]

Thread overview: 19+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-05-25  3:45 [PATCH v5 0/8] Enable ili9341 and l3gd20 on stm32f429-disco dillon.minfei
2020-05-25  3:45 ` [PATCH v5 1/8] ARM: dts: stm32: Add dma config for spi5 dillon.minfei
2020-05-25  3:45 ` [PATCH v5 2/8] ARM: dts: stm32: Add pin map for ltdc & spi5 on stm32f429-disco board dillon.minfei
2020-05-25  3:45 ` dillon.minfei [this message]
2020-05-25  3:45 ` [PATCH v5 4/8] dt-bindings: display: panel: Add ilitek ili9341 panel bindings dillon.minfei
2020-05-25 12:20   ` Linus Walleij
2020-05-25  3:45 ` [PATCH v5 5/8] clk: stm32: Fix stm32f429's ltdc driver hang in set clock rate, fix duplicated ltdc clock register to 'clk_core' case ltdc's clock turn off by clk_disable_unused() dillon.minfei
2020-05-27  1:44   ` Stephen Boyd
2020-05-27  3:30     ` dillon min
2020-05-25  3:45 ` [PATCH v5 6/8] drm/panel: Add ilitek ili9341 panel driver dillon.minfei
2020-05-25 12:23   ` Linus Walleij
2020-05-26  7:46   ` Andy Shevchenko
2020-05-26  9:08     ` dillon min
2020-05-26 10:38       ` Noralf Trønnes
2020-06-30 15:32         ` dillon min
2020-05-25  3:45 ` [PATCH v5 7/8] spi: stm32: Add 'SPI_SIMPLEX_RX', 'SPI_3WIRE_RX' support for stm32f4 dillon.minfei
2020-05-25  3:45 ` [PATCH v5 8/8] spi: flags 'SPI_CONTROLLER_MUST_RX' and 'SPI_CONTROLLER_MUST_TX' can't be coexit with 'SPI_3WIRE' mode dillon.minfei
2020-05-26  9:19 ` [PATCH v5 0/8] Enable ili9341 and l3gd20 on stm32f429-disco Mark Brown
     [not found] <broonie@kernel.org>
2020-05-25  3:40 ` dillon.minfei
2020-05-25  3:40   ` [PATCH v5 3/8] ARM: dts: stm32: enable ltdc binding with ili9341, gyro l3gd20 on stm32429-disco board dillon.minfei

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1590378348-8115-4-git-send-email-dillon.minfei@gmail.com \
    --to=dillon.minfei@gmail.com \
    --cc=broonie@kernel.org \
    --cc=devicetree@vger.kernel.org \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=linus.walleij@linaro.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-clk@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-spi@vger.kernel.org \
    --cc=linux-stm32@st-md-mailman.stormreply.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).