From mboxrd@z Thu Jan 1 00:00:00 1970 From: lee.jones@linaro.org (Lee Jones) Date: Fri, 11 Jul 2014 09:24:25 +0100 Subject: [PATCH 2/3] usb: host: st-hcd: Add st-hcd devicetree bindings documentation. In-Reply-To: <1405005486-26355-3-git-send-email-peter.griffin@linaro.org> References: <1405005486-26355-1-git-send-email-peter.griffin@linaro.org> <1405005486-26355-3-git-send-email-peter.griffin@linaro.org> Message-ID: <20140711082425.GJ11948@lee--X1> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Thu, 10 Jul 2014, Peter Griffin wrote: > This patch documents the device tree documentation required for > the ST HCD controller found in STMicroelectronics SoCs. > > Signed-off-by: Peter Griffin > --- > Documentation/devicetree/bindings/usb/st-hcd.txt | 51 ++++++++++++++++++++++++ > 1 file changed, 51 insertions(+) > create mode 100644 Documentation/devicetree/bindings/usb/st-hcd.txt Just some nits: > +Example: > + > +usb0: usb at fe100000 { > + compatible = "st,usb-300x"; > + reg = <0xfe1ffc00 0x100>, > + <0xfe1ffe00 0x100>; > + reg-names = "ohci", "ehci"; > + > + interrupts = , > + ; > + interrupt-names = "ehci","ohci"; s/","/", " > + pinctrl-names = "default"; > + pinctrl-0 = <&pinctrl_usb0>; > + clocks = <&clk_s_a1_ls CLK_ICN_IF_2>, > + <&clockgen_b0 0>; > + clock-names = "ic", "ohci"; > + > + resets = <&powerdown STIH416_USB0_POWERDOWN>, > + <&softreset STIH416_USB0_SOFTRESET>; > + reset-names = "power", "softreset"; > + > + phys = <&usb2_phy>; > + phy-names = "usb2-phy"; Tabbing of the '='s not consistent. > +}; > + > + Too many '\n' at EOF. Nothing controversial here, so once this nits are rectified: Acked-by: Lee Jones -- Lee Jones Linaro STMicroelectronics Landing Team Lead Linaro.org ? Open source software for ARM SoCs Follow Linaro: Facebook | Twitter | Blog