[PATCH 3/3] crypto: Add Allwinner Security System crypto accelerator

[herbert@gondor.apana.org.au (Herbert Xu)]

On Wed, Jul 23, 2014 at 04:07:20PM +0200, Marek Vasut wrote:
> On Wednesday, July 23, 2014 at 03:57:35 PM, Herbert Xu wrote:
> > On Sat, May 24, 2014 at 02:00:03PM +0200, Marek Vasut wrote:
> > > > +	}
> > > > +#endif
> > > > +
> > > > +#ifdef CONFIG_CRYPTO_DEV_SUNXI_SS_MD5
> > > > +	err = crypto_register_shash(&sunxi_md5_alg);
> > > 
> > > Do not use shash for such device. This is clearly and ahash (and async in
> > > general) device. The rule of a thumb here is that you use sync algos only
> > > for devices which have dedicated instructions for computing the
> > > transformation. For devices which are attached to some kind of bus, you
> > > use async algos (ahash etc).
> > 
> > I'm sorry that I didn't catch this earlier but there is no such
> > rule.
> > 
> > Unless you need the async interface you should stick to the sync
> > interfaces for the sake of simplicity.
> > 
> > We have a number of existing drivers that are synchronous but
> > using the async interface.  They should either be converted
> > over to the sync interface or made interrupt-driven if possible.
> 
> Sure, but this device is interrupt driven and uses DMA to feed the crypto 
> engine, therefore async, right ?

If it's interrupt-driven, then yes it would certainly make sense to
be async.  But all I see is polling in the latest posting, was the
first version different?

Cheers,
-- 
Email: Herbert Xu <herbert@gondor.apana.org.au>
Home Page: http://gondor.apana.org.au/~herbert/
PGP Key: http://gondor.apana.org.au/~herbert/pubkey.txt