From mboxrd@z Thu Jan 1 00:00:00 1970 From: maxime.ripard@free-electrons.com (Maxime Ripard) Date: Sat, 25 Jun 2016 09:18:09 +0200 Subject: [PATCH v2 13/14] ARM: dts: sun8i: Add gpio-regulator used on Orange Pi One In-Reply-To: <20160625034511.7966-14-megous@megous.com> References: <20160625034511.7966-1-megous@megous.com> <20160625034511.7966-14-megous@megous.com> Message-ID: <20160625071808.GE4000@lukather> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Sat, Jun 25, 2016 at 05:45:10AM +0200, megous at megous.com wrote: > From: Ondrej Jirman > > Xulong Orange Pi One uses GPIO based regulator that > switches between two voltages: 1.1V and 1.3V. The > regulator is controlled from the PL6 pin. > > Signed-off-by: Ondrej Jirman > --- > v2 > - add missing pinctrl-names for gpio-regulator > --- > arch/arm/boot/dts/sun8i-h3-orangepi-one.dts | 26 ++++++++++++++++++++++++++ > 1 file changed, 26 insertions(+) > > diff --git a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts > index 0adf932..b1bd6b0 100644 > --- a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts > +++ b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts > @@ -88,6 +88,25 @@ > gpios = <&r_pio 0 3 GPIO_ACTIVE_LOW>; > }; > }; > + > + vdd_soc: gpio-regulator { > + compatible = "regulator-gpio"; > + pinctrl-names = "default"; > + pinctrl-0 = <&vdd_reg_r_opc>; > + > + regulator-name = "soc-vdd-supply"; > + regulator-min-microvolt = <1100000>; > + regulator-max-microvolt = <1300000>; > + regulator-boot-on; > + regulator-type = "voltage"; It should be marked as always-on. Otherwise, if the cpufreq driver is not enabled, the regulator will be shutdown, which is not that great :) Maxime -- Maxime Ripard, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: not available URL: