From mboxrd@z Thu Jan 1 00:00:00 1970 From: takahiro.akashi@linaro.org (AKASHI Takahiro) Date: Mon, 3 Apr 2017 11:24:40 +0900 Subject: [PATCH v35 12/14] Documentation: kdump: describe arm64 port In-Reply-To: <20170403022139.12383-1-takahiro.akashi@linaro.org> References: <20170403022139.12383-1-takahiro.akashi@linaro.org> Message-ID: <20170403022440.12515-10-takahiro.akashi@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Add arch specific descriptions about kdump usage on arm64 to kdump.txt. Signed-off-by: AKASHI Takahiro Reviewed-by: Baoquan He Acked-by: Dave Young Acked-by: Catalin Marinas --- Documentation/kdump/kdump.txt | 16 +++++++++++++++- 1 file changed, 15 insertions(+), 1 deletion(-) diff --git a/Documentation/kdump/kdump.txt b/Documentation/kdump/kdump.txt index b0eb27b956d9..615434d81108 100644 --- a/Documentation/kdump/kdump.txt +++ b/Documentation/kdump/kdump.txt @@ -18,7 +18,7 @@ memory image to a dump file on the local disk, or across the network to a remote system. Kdump and kexec are currently supported on the x86, x86_64, ppc64, ia64, -s390x and arm architectures. +s390x, arm and arm64 architectures. When the system kernel boots, it reserves a small section of memory for the dump-capture kernel. This ensures that ongoing Direct Memory Access @@ -249,6 +249,13 @@ Dump-capture kernel config options (Arch Dependent, arm) AUTO_ZRELADDR=y +Dump-capture kernel config options (Arch Dependent, arm64) +---------------------------------------------------------- + +- Please note that kvm of the dump-capture kernel will not be enabled + on non-VHE systems even if it is configured. This is because the CPU + will not be reset to EL2 on panic. + Extended crashkernel syntax =========================== @@ -305,6 +312,8 @@ Boot into System Kernel kernel will automatically locate the crash kernel image within the first 512MB of RAM if X is not given. + On arm64, use "crashkernel=Y[@X]". Note that the start address of + the kernel, X if explicitly specified, must be aligned to 2MiB (0x200000). Load the Dump-capture Kernel ============================ @@ -327,6 +336,8 @@ For s390x: - Use image or bzImage For arm: - Use zImage +For arm64: + - Use vmlinux or Image If you are using a uncompressed vmlinux image then use following command to load dump-capture kernel. @@ -370,6 +381,9 @@ For s390x: For arm: "1 maxcpus=1 reset_devices" +For arm64: + "1 maxcpus=1 reset_devices" + Notes on loading the dump-capture kernel: * By default, the ELF headers are stored in ELF64 format to support -- 2.11.1