From mboxrd@z Thu Jan 1 00:00:00 1970 From: miquel.raynal@bootlin.com (Miquel Raynal) Date: Fri, 23 Nov 2018 15:18:27 +0100 Subject: [PATCH 08/12] dt-bindings: PCI: aardvark: describe the PHY property In-Reply-To: <20181123141831.8214-1-miquel.raynal@bootlin.com> References: <20181123141831.8214-1-miquel.raynal@bootlin.com> Message-ID: <20181123141831.8214-9-miquel.raynal@bootlin.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Document the possibility to reference a PHY. Signed-off-by: Miquel Raynal --- Documentation/devicetree/bindings/pci/aardvark-pci.txt | 2 ++ 1 file changed, 2 insertions(+) diff --git a/Documentation/devicetree/bindings/pci/aardvark-pci.txt b/Documentation/devicetree/bindings/pci/aardvark-pci.txt index c275c3e39cde..b41c69968e38 100644 --- a/Documentation/devicetree/bindings/pci/aardvark-pci.txt +++ b/Documentation/devicetree/bindings/pci/aardvark-pci.txt @@ -24,6 +24,7 @@ contain the following properties: The following are optional properties: - reset-gpios: GPIO to reset the device + - phys: the PCIe PHY handle In addition, the Device Tree describing an Aardvark PCIe controller must include a sub-node that describes the legacy interrupt controller @@ -55,6 +56,7 @@ Example: <0 0 0 3 &pcie_intc 2>, <0 0 0 4 &pcie_intc 3>; reset-gpios = <&gpiosb 3 GPIO_ACTIVE_HIGH>; + phys = <&comphy1 0>; pcie_intc: interrupt-controller { interrupt-controller; #interrupt-cells = <1>; -- 2.19.1