Linux-ARM-Kernel Archive on lore.kernel.org
 help / color / Atom feed
From: Miquel Raynal <miquel.raynal@bootlin.com>
To: Gregory Clement <gregory.clement@bootlin.com>,
	Jason Cooper <jason@lakedaemon.net>, Andrew Lunn <andrew@lunn.ch>,
	Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com>,
	Kishon Vijay Abraham I <kishon@ti.com>
Cc: devicetree@vger.kernel.org,
	Antoine Tenart <antoine.tenart@bootlin.com>,
	Grzegorz Jaszczyk <jaz@semihalf.com>,
	Russell King <linux@armlinux.org.uk>,
	Maxime Chevallier <maxime.chevallier@bootlin.com>,
	Nadav Haklai <nadavh@marvell.com>,
	Rob Herring <robh+dt@kernel.org>,
	Thomas Petazzoni <thomas.petazzoni@bootlin.com>,
	Miquel Raynal <miquel.raynal@bootlin.com>,
	linux-arm-kernel@lists.infradead.org
Subject: [PATCH v3 12/19] phy: mvebu-cp110-comphy: Update comment about powering off all lanes at boot
Date: Wed, 31 Jul 2019 14:21:19 +0200
Message-ID: <20190731122126.3049-13-miquel.raynal@bootlin.com> (raw)
In-Reply-To: <20190731122126.3049-1-miquel.raynal@bootlin.com>

Now that all COMPHY modes are supported by the driver, update the
comment stating that mvebu_comphy_power_off() should be called for
each lane. This is still wrong because for compatibility reasons, it
might break users running an old firmware (the driver only uses SMC
calls for SATA, USB and PCIe configuration, there is no code in Linux
to fallback on in these cases.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
---
 drivers/phy/marvell/phy-mvebu-cp110-comphy.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
index 076b2bfa8e7b..24fdec43a8e0 100644
--- a/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
+++ b/drivers/phy/marvell/phy-mvebu-cp110-comphy.c
@@ -944,9 +944,11 @@ static int mvebu_comphy_probe(struct platform_device *pdev)
 		phy_set_drvdata(phy, lane);
 
 		/*
-		 * Once all modes are supported in this driver we should call
+		 * All modes are supported in this driver so we could call
 		 * mvebu_comphy_power_off(phy) here to avoid relying on the
-		 * bootloader/firmware configuration.
+		 * bootloader/firmware configuration, but for compatibility
+		 * reasons we cannot de-configure the COMPHY without being sure
+		 * that the firmware is up-to-date and fully-featured.
 		 */
 	}
 
-- 
2.20.1


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

  parent reply index

Thread overview: 30+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2019-07-31 12:21 [PATCH v3 00/19] Enhance CP110 COMPHY support Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 01/19] phy: mvebu-cp110-comphy: Add clocks support Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 02/19] phy: mvebu-cp110-comphy: Explicitly initialize the lane submode Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 03/19] phy: mvebu-cp110-comphy: Add SMC call support Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 04/19] phy: mvebu-cp110-comphy: List already supported Ethernet modes Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 05/19] phy: mvebu-cp110-comphy: Add RXAUI support Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 06/19] phy: mvebu-cp110-comphy: Rename the macro handling only Ethernet modes Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 07/19] phy: mvebu-cp110-comphy: Allow non-Ethernet modes to be configured Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 08/19] phy: mvebu-cp110-comphy: Add USB3 host/device support Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 09/19] phy: mvebu-cp110-comphy: Add SATA support Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 10/19] phy: mvebu-cp110-comphy: Cosmetic change in a helper Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 11/19] phy: mvebu-cp110-comphy: Add PCIe support Miquel Raynal
2019-07-31 12:21 ` Miquel Raynal [this message]
2019-07-31 12:21 ` [PATCH v3 13/19] dt-bindings: phy: Add Marvell COMPHY clocks Miquel Raynal
2019-08-12 21:29   ` Rob Herring
2019-08-19  8:40     ` Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 14/19] dt-bindings: pci: add PHY properties to Armada 7K/8K controller bindings Miquel Raynal
2019-08-21 18:28   ` Rob Herring
2019-08-24 10:15     ` Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 15/19] arm64: dts: marvell: Add CP110 COMPHY clocks Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 16/19] arm64: dts: marvell: Add 7k/8k per-port PHYs in SATA nodes Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 17/19] arm64: dts: marvell: Add 7k/8k PHYs in USB3 nodes Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 18/19] arm64: dts: marvell: Add 7k/8k PHYs in PCIe nodes Miquel Raynal
2019-07-31 12:21 ` [PATCH v3 19/19] arm64: dts: marvell: Convert 7k/8k usb-phy properties to phy-supply Miquel Raynal
2019-08-23  3:16 ` [PATCH v3 00/19] Enhance CP110 COMPHY support Kishon Vijay Abraham I
2019-08-23  7:33   ` Miquel Raynal
2019-08-24 11:54   ` Miquel Raynal
2019-08-26 11:51     ` Kishon Vijay Abraham I
2019-08-26 12:23       ` Miquel Raynal
2019-08-27 14:22 ` Gregory CLEMENT

Reply instructions:

You may reply publically to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20190731122126.3049-13-miquel.raynal@bootlin.com \
    --to=miquel.raynal@bootlin.com \
    --cc=andrew@lunn.ch \
    --cc=antoine.tenart@bootlin.com \
    --cc=devicetree@vger.kernel.org \
    --cc=gregory.clement@bootlin.com \
    --cc=jason@lakedaemon.net \
    --cc=jaz@semihalf.com \
    --cc=kishon@ti.com \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux@armlinux.org.uk \
    --cc=maxime.chevallier@bootlin.com \
    --cc=nadavh@marvell.com \
    --cc=robh+dt@kernel.org \
    --cc=sebastian.hesselbarth@gmail.com \
    --cc=thomas.petazzoni@bootlin.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

Linux-ARM-Kernel Archive on lore.kernel.org

Archives are clonable:
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/0 linux-arm-kernel/git/0.git
	git clone --mirror https://lore.kernel.org/linux-arm-kernel/1 linux-arm-kernel/git/1.git

	# If you have public-inbox 1.1+ installed, you may
	# initialize and index your mirror using the following commands:
	public-inbox-init -V2 linux-arm-kernel linux-arm-kernel/ https://lore.kernel.org/linux-arm-kernel \
		linux-arm-kernel@lists.infradead.org infradead-linux-arm-kernel@archiver.kernel.org
	public-inbox-index linux-arm-kernel

Example config snippet for mirrors

Newsgroup available over NNTP:
	nntp://nntp.lore.kernel.org/org.infradead.lists.linux-arm-kernel


AGPL code for this site: git clone https://public-inbox.org/ public-inbox